MCC 4354776 1 PVC Pipe Cutter Instruction Manual

June 13, 2024
MCC

1” PVC Pipe Clutter
Item No. VC-0334
Instruction Manual

 Introduction

This manual provides the user with basic operating and safety instruction about this product. For your own safety, carefully read this manual before use and learn the potential hazards. This product is designed for one-handed cutting of plastic pipe with ratchet action.

Capacity & Materials to be cut

Use this product only on the following materials and capacity.

  • Materials to be cut: PVC, CPVC, PE, PEX, ABS pipe Information for use on other materials, please contact your distributor or MCC customer service.

Cutting Capacity (Pipe 0.D.) :  upto11/3″ (34 mm)
WARNING
Sharp! Do not touch the blade or blade edge with fingers or hands.
Wear protective gloves and glasses during operation or maintenance.
Do not touch the ratchet gear while operating in order to avoid pinching your finger or hand.
CAUTION
Always check materials and diameter to be cut. Never cut materials other than as described. Do not twist the cutter or pipe while cutting otherwise it may cause damage to blade. Before cutting work, remove any mud or foreign objects on the pipe in order to avoid any damage to the blade. Do not hang the cutter only by a hook in order to prevent it from falling and breaking. Throwing, dropping, or any other rough handling of the cutter  may cause breakage or damage to the cutter. For maximizing the tool life, maintain the cutter in good working condition and never operate the cutter with any damage.

MHow to Operate

First clean the pipe to be cut, remove any objects on the pipe.

MCC 4354776 1 PVC Pipe Cutter - Fig1Unhook the handles and open the handles & blade. Tuck the hook into the handle while | operating. Place a pipe in the jaw.

MCC 4354776 1 PVC Pipe Cutter - Fig2

Keep ratcheting (; open handle and close repeatedly) feeling each ratchet click until cutis completed. Wide open handle will release blade.
To properly cut old pipes or pipe in cold temperature, warm up the pipe and cut very slowly to avoid cracking or shattering the pipe.
For thin wall PVC pipe such as Class 200, lightly squeeze the handles while rotating them up and down when the blade edge just starts cutting into the pipe. This helps the blade to penetrate the wall of pipe without deforming the pipe.

W Replacement Blade

Periodical replacement of blade prolongs the lifetime of tool. It becomes very economical in the long run by doing so. Use only the blade listed below.

  • Model No. VCE0334 (Replacement blade for VC-0334)

MCC Corporation www.MCCinter.com
US Sales Office
MCC USAINC. wwwMCCusainc.com

http://www.mccinter.com/plastic-pipe-cutters/

Distributor for your country/region
WARNING
This product can expose you to chemicals including Ethylbenzene, which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov.

MADE IN JAPAN

Documents / Resources

| MCC 4354776 1 PVC Pipe Cutter [pdf] Instruction Manual
4354776 1 PVC Pipe Cutter, 4354776 1, PVC Pipe Cutter, Pipe Cutter, Cutter
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals