MARLEY 10723440 Heating Saving Complete Set User Manual

: June 13, 2024
: MARLEY

Table of Contents

MARLEY 10723440 Heating Saving Complete Set
Product Information
Product Usage Instructions
Operating/assembly instructions
Wiring
Installation
Remote control
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

MARLEY 10723440 Heating Saving Complete Set

Product Information

The Heat Energy Saving Set is a device designed to save energy in heating systems. It operates on a 24V DC motor and has a maximum power input of 2.5W. The set has a protection rating of IP24 and an operational performance of 51 m3/h. It operates at a frequency range of 433.82 – 434.02 MHz and has a transmission power of 58dBm. The set uses a CR2025 battery.

Product Usage Instructions

Before using the Heat Energy Saving Set, make sure you have read and understood the operating/assembly instructions.
Ensure that the set is installed in accordance with the provided instructions.
Connect the set to a power source with a voltage of 24V DC.
Make sure the set is properly protected with its IP24 rating.
To control the set, use the provided ON/OFF switch.
Adjust the speed of the motor as needed using the available settings.
Monitor the sound pressure level to ensure it is within acceptable limits.
Replace the CR2025 battery when needed.
Refer to the technical data for any modifications or changes to the product.

Operating/assembly instructions

Assembly instructions heat energy saving set – heat distribution from room to room. Please read these assembly and commissioning instructions carefully before starting the installation.
Warnings:
Note: All work should be done with no electrical current. Electrical connections must only be done by an authorized tradesman to the applicable regulations. Voltage and electrical power supply must be compatible to the specification of the device. An all pole separator from current with a contact opening of minimum 3 mm is specified for the installation. Installation in rooms with high moisture or damp areas must be done according to DIN/VDE 0100 T701.

This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. If you operate a fireplace dependent on the room air at the location you intend to use the device, please ensure on all accounts that there is sufficient ventilation, especially if the building shell is airtight.
The relevant, applicable regulations for the joint operation of fireplaces (gas boilers, chimneys, extractor hoods, etc.) and controlled airing and ventilation must be taken into consideration. Please contact your district chimney sweep if you have any questions.

You can find further information on this product at www.marley.de.

The device is operated within a building and should be installed at least 0.8m from the wall end and 0.3m from the ceiling.

Installation Instructions Heat energy saving set

**Technical data* Heat energy saving set**

Wiring

Installation

Remote control

Disposal
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer wherethe product was purchased. They can take this product for environmental safe recycling.

Hereby, Marley Deutschland GmbH declares that the radio equipment types Heiz- Spar-Set, RE-VENTI MS125E DC and MENVFB are in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: