ENDON 104052 Allegra Wall Light Instruction Manual

: June 13, 2024
: ENDON

Table of Contents

ENDON 104052 Allegra Wall Light
Product Information
Product Usage Instructions
Safety Warnings
Care and maintenance
Troubleshooting
Assembly Instructions
Read User Manual Online (PDF format)
Download This Manual (PDF format)

ENDON 104052 Allegra Wall Light

Product Information

This product is a wall light fitting designed for indoor use. It should be connected to a 220 -240V~ 50Hz power supply in accordancewith current IEE wiring regulations. The product should be installed in compliance with local building regulations and is not suitable for use in a bathroom location. Please consult a qualified electrician if you have any doubts about installing this product.
It is important to note that this product should not have anything placed on it or have any items hung on any part of it.
Ensure that all electrical connections are tight and no loose strands are left out of the terminal. It is crucial not to fit bulbs with a higher wattage than specified on the label, as this may cause overheating and damage to the fitting.
Proper disposal of waste electrical products is essential. Please recycle where facilities exist. Check with your Local Authority or local store for recycling advice.
Cleaning and maintenance should be done with a dry cloth only. Do not use liquid or abrasive cleaners on this product.

Product Usage Instructions

Bulb Replacement: To replace the bulb, switch off the product and preferably isolate it at the distribution board. Allow the product to cool down, as the bulb may become hot during use.
Troubleshooting: If the bulb does not light after installation, follow these steps:
- Ensure there is no electricity failure.
- Ensure all connections are secure.
- If you are unsure about the installation or use of this product, consult a qualified electrician.

Please refer to the assembly instructions provided with the product for detailed guidance on how to assemble it.

Manufacturers:

UK Manufacturer: BH17 7BY
EU Manufacturer: Brilliant AG, Brilliantstrasse 1, D-27442

Safety Warnings

These instructions are for your safety. Please read through them thoroughly before use and retain them for future reference. If you are in any doubt about installing this product, consult a qualified electrician.
This product is only suitable for connection to a 220-240V~ 50Hz supply in accordance with current IEE wiring regulations, and should be installed in accordance with local building regulations. It is for indoor use only, and is not suitable for a bathroom location.
This is a Class l product and must be Earthed. The terminal blocks are supplied according to requirements
of the fitting.
IMPORTANT : Always switch off the mains supply during installation or maintenance. We recommend that the fuse is withdrawn or the circuit breaker switched off at the distribution board whilst work is in progress (turning off the light switch is not sufficient). Connection should be via a wall switch to enable safe isolation.
The product must be securely fixed to the mounting surface using the screws and wall plugs supplied. The screws and wall plugs supplied are suitable for “masonry” only. Other fixings are not supplied and must be purchased.
Decide on the position of the light fitting or remove existing light fitting. Note the position of the electrical connections, and ensure there is a solid mounting surface, Preferably a wooden joist or joist bridge, to support the weight of the light fitting.
Take care not to drill into any pipes or mains cables beneath the surface during mounting holes preparation.
Never put anything on the product or hang anything on any part of this product.
IMPORTANT : Ensure that all electrical connections are tight and that no loose strands are left out of the terminal.
Never fit bulbs of a higher wattage than those specified on the label (as these may cause over heating and damage the fitting).
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or local store for recycling advice.

Care and maintenance

For bulb replacement, switch off the product (preferably, isolate it at the distribution board) and allow it to cool down (Caution: bulb gets hot during use).
Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.