sudio K2 Wireless Headphone Instruction Manual
- June 13, 2024
- Sudio
Table of Contents
sudio K2 Wireless Headphone
Included in the box
- K2
- Charging cable
- warnings folder
- owners Manual
Pairing to a device
- Turn on K2 by holding the button for 3 seconds
- Connect to device
Low battery
LED blinks amber when battery is low (0-10%)
Charging
Charge with USB-C. Amber light = charging.
White light = fully charged
Playback operations
- :1tap
- : Tap 2x
- : Tap 3x
- Vol : Hold 2s
- Vol : Hold 3s
Phone call operations
- Accept calls: 1 tap
- Hang up or reject calls: Hold R side 2 seconds
Active Noise Cancelling (ANC)
Turn on off ANC by holding the button 2 seconds
Factory reset
- Turn off K2 by holding the button 4s
- Hold button 10s
- The LED will blink 2x
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio TV technician for help.
RF warning statement:
The device has been evaluated to meet general F exposure requirement. The
device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>