Endon 106244 Clifton 5 Light Instruction Manual
- June 13, 2024
- ENDON
Table of Contents
Endon 106244 Clifton 5 Light
Product Information
The Pendant Light Fitting is designed for domestic ceiling use and is suitable for connection to a 220-240V~ 50Hz supply. It is a Class l product and must be Earthed. The terminal blocks are supplied according to the requirements of the fitting. Please note that this product is not suitable for use in a bathroom location.
Safety Warnings
- Please read and thoroughly understand the installation and safety instructions before using the product.
- If you are unsure about installing the product, consult a qualified electrician.
- Ensure that the product is installed in accordance with local building regulations and current IEE wiring regulations.
- Never put anything on the product or hang anything on any part of it.
- Do not use bulbs with a higher wattage than specified on the label, as this may cause overheating and damage to the fitting.
- Dispose of waste electrical products responsibly by recycling them where facilities exist.
- These instructions are for your safety. Please read through them thoroughly before use and retain them for future reference. If you are in any doubt about installing this product, consult a qualified electrician. This product is only suitable for connection to a 220-240V~ 50Hz supply in accordance with current IEE wiring regulations, and should be installed in accordance with local building regulations. It is for domestic ceiling use only, and is not suitable for a bathroom location.
- IMPORTANT : Always switch off the mains supply during installation or maintenance. We recommend that the fuse is withdrawn or the circuit breaker switched off at the distribution board whilst work is in progress (turning off the light switch is not sufficient). Connection should be via a wall switch to enable safe isolation.
- The product must be securely fixed to the mounting surface using the screws and wall plugs supplied. The screws and wall plugs supplied are suitable for “masonry” only. Other fixings are not supplied and must be purchased.
- Decide on the position of the light fitting or remove existing light fitting. Note the position of the electrical connections, and ensure there is a solid mounting surface, Preferably a wooden joist or joist bridge, to support the weight of the light fitting.
- Take care not to drill into any pipes or mains cables beneath the surface during mounting holes preparation.
- Never put anything on the product or hang anything on any part of this product.
- IMPORTANT : Ensure that all electrical connections are tight and that no loose strands are left out of the terminal.
- Never fit bulbs of a higher wattage than those specified on the label (as these may cause over heating and damage the fitting).
- Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or local store for recycling advice.
Care and maintenance
For bulb replacement, switch off the product (preferably, isolate it at the distribution board) and allow it to cool down ( Caution : bulb gets hot during use). Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.
Troubleshooting
If the bulb does not light after installation, follow these steps:
- Ensure there is no electricity failure.
- Check that all connections are secure.
- If you are still unsure, consult a qualified electrician.
Assembly Instructions
This product may require assembly. Please refer to the adjustable assembly
instructions provided. Note that adjustable parts are not included.
UK Manufacturer: BH17 7BY
EU Manufacturer : Brilliant AG, Brilliantstrasse 1, D-27442 Gnarrenburg.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>