SoundCore Boost Portable Speaker A3145011 User Manual

: June 13, 2024
: Soundcore

SoundCore Boost Portable Speaker A3145011

USER MANUAL

Product Number A3145 &,JI r!J
Bluetooth Speaker/ SoundCore Boost
57005007070 V04

What’s In The Box

Overview

Safety Instructions

1. Avoid dropping.
2. Do not disassemble.
3. Do not submerge in water.
4. Avoid extreme temperatures.
5. Use original or certified cables.
6. Do not use any corrosive cleaner/oil to clean.
7. Do not use the device outdoors during thunderstorms.

Charge Your SoundCore

Charge USB Devices

Turn on/ off

Bluetooth Pairing

NFC Pairing

Note: To break connection, tap again the NFC device onto SoundCore’s NFC detection area.

Connect via AUX

Sound line AUX cable sold separately

Note: To return to Bluetooth mode, remove the AUX cable from your Sound Core.

Controls

Specifications

Specifications are subject to change without notice.

Input:	5 V 2 A
Charge out:	5 V 1 A
Audio output:	10 w x 2
Charging time:	4-6 hours
Play time (varies by volume level and music content):	12 hours
Size:	193 x 62 x 65mm/; 7.7 X 2.4 X 2.6 in
Weight (without packaging):	585 g / 20.6 oz
Bluetooth version:	V 4.2
Bluetooth range:	20 m/66 ft
Waterproof rating	IPX 5
Driver (full range)	1.75″ X 2
Audio output
Charging time	4-6 hours
Battery capacity	5200 mAh
Impedance	4
Frequency response	70 Hz – 20 KHz

Notice

CE : This product complies with the radio interference requirements of the European Community.

CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS

This symbol means the product must not be discarded as household waste, and should be delivered to an appropriate collection facility for recycling. Proper disposal and recycling helps protect natural resources, human health and the environment. For more information on disposal and recycling of this product, contact your local municipality, disposal service, or the shop where you bought this product.

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/ TV technician for help.

RF Warning Statement

The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

Trademark

Bluetooth

The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such marks by Anker Technology Co., Limited is under license. Other trademarks and trade names are those of their respective owners.

This product complies with the radio interference requirements of the European Community.

Declaration of Conformity

Hereby, Anker Technology Co., Limited declares that the radio equipment type A3145 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address:
www.anker.com
Maximum output power: 1.SdBm
Frequency band: 2.4G band (2.4000GHz-2.4835GHz)

IC NOTICE TO CANADIAN USERS

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device. This device complies with RSS-247 of Industry Canada. Operation is subject to the condition that this device does not cause harmful interference. This Class B digital apparatus complies with Canadian ICES-003 (Cet appareil numerique de la Classe B conforme a la norme NMB-003 du Canada).