GEARLIGHT BT-FL8014-10W S2000 LED Flashlight Installation Guide
- June 13, 2024
- GearLight
Table of Contents
GEARLIGHT BT-FL8014-10W S2000 LED Flashlight Installation Guide
CAUTION: The flashlight may become warm or hot after extended periods of use at the highest setting. Select a lower setting when the flashlight is hot. This is typical for high-powered flashlights and does not cause damage to the flashlight.
OPERATION
On/Off
- To turn the flashlight on, press down firmly on the red power button located on the tail of the flashlight until you hear a click.
- To turn the flashlight of, press down firmly again until you hear a click.
Switching Modes
- Switching Modes There are 5 deferent lighting modes. (High, Medium, Low, Strobe, SOS)
- To switch through the deferent lighting modes, gently press down on the red power button to alternate through the 5 modes.
- The flashlight will switch to the next mode when turned of and on in quick succession. It will reset back to the highest mode after being of for more than 10 seconds.
Zoom
- Hold both ends of the flashlight; gently twist and pull each end away from the other.
- Pull the two ends away from each other to zoom in and push the two ends together to zoom out.
WARNING: To avoid eye injury, do not stare directly into the light beam
or shine the beam directly into anyone’s eyes. This product is not designed,
intended, or recommended for children or hazardous environments.
WARNING: Always follow the battery manufacturer’s instructions as to the proper usage, handling, storage, and disposal of batteries. Use only batteries from a reputable manufacturer. Do not mix deferent brands or types of batteries in the same flashlight. Replace all batteries at the same time. Immediately remove batteries from a defective flashlight. Failure to follow safety instructions may result in personal injury and damage to property
GETTING STARTED
AA Battery Installation
- Unfasten tail cap and remove battery holder.
- Insert 4 AA batteries following the correct polarity (+,-) marked on the battery holder.
- Insert the battery holder back into the flashlight with the positive (+) end first.
TROUBLESHOOTING
If the flashlight does not turn on, or works intermittently:
- If the flashlight does not turn on, or works intermittently:
- Replace the batteries.
- Make sure the tail cap is twisted on tightly and batteries are inserted correctly.
- If the flashlight flickers or changes modes automatically:
- Make sure the tail cap is twisted on tightly.
- If light appears dim or faded:
- Replace the batteries.
If problem persists: LED Failure. Contact GearLight for replacement.
MAINTENANCE
Inspect the flashlight monthly and carefully remove any damaged batteries and clean any corrosion. If the flashlight is used less than once a month, remove the batteries between uses. Lubricate all threads and rubber O-rings with petroleum jelly twice yearly
WARRANTY AND LIMITATION OF LIABILITY
Limited One-Year Warranty
GearLight warrants this product for one year from the date of purchase against
any defects in material or workmanship. This warranty does not cover normal
wear and tear, nor damage resulting from misuse or neglect. We will, at our
discretion, repair, replace, or refund the purchase price of this product
should we determine it to be defective.
Limitation Of Liability
Liability limited to the purchase price of this product. GearLight shall not
be liable for any incidental or consequential damages or any implied warranty
on this product. Some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation or exclusion may
not apply to you.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>