LIAN LI O11DE Upright GPU Bracket Instructions
- June 13, 2024
- LIAN LI
Table of Contents
O11DE Upright GPU Bracket
Upright GPU Bracket for 40 Series GPU- O11DE-9X / O11DE-9W
Upright GPU Bracket Upgrade Kit for 40 Series GPU- O11DE-10X / O11DE-10W
Package contents
O11DE-9X(W) includes all A ~ J , O11DE-
10X(W) only includes B , H, I, J .
O11DE-10X(W) must use with components from O11DE-2X(W) or O11DE-6X(W).
Installation
Install the upright GPU holder to the back bracket. Remove the graphics card mounting tray. Install at the 1st slot and plug the display output cable. Install at the 2nd slot and plug the display output cable. Installation for GPU mount at the first slot. Installation for GPU mount at the second slot. **** Water block GPU width clearence :
First slot | ≦151 mm |
---|---|
Second slot | ≦158 mm |
Height adjustable according to the GPU length and the power connection position. Graphics card width measurement. There are 5 ways to install the big L-type support bracket in 2 directions. Refer to below supporting GPU width and the socket for power cable to determine which way to install. GPU supporting width
****
- MB width maximum: 244mm.
- Careful to avoid MB sockets.
- Recommend install way 1 when mounting O11DE-4X(W), to avoid interference with the fan bracket.
**** Can’t mount way 2 & 3 when installing 120 mm fan on the fan bracket.
Screw with D.
Screw with D, won’t fit when Installing a 120 mm fan.Fan installation is required at this stage
if needed. Mount the fans toward the bottom (as bellow right image) to leave
space for bracket installation. Plug in the output wires and install the
tray back.
- Route the signal cable through the top of the fan bracket.
- Connect the PCIe riser cable to the GPU then route the cable to the 2nd chamber (remove the rubber grommets if needed).
- Pass the 12VHPWR cable from the PSU through the rubber grommets beforehand.
- Install the GPU with the back bracket to the fan bracket.
*Please purchase the PCI cable PW-PCI-4-60X(W)
Place the tabs of the back bracket into the 140 mm fan OB hole of the fan
bracket, and push the back bracket inwards and screw it on. When the fan is
installed, the screws in the box at below image cannot be screwed. Not
screwing it won’t affect the use of the holder. Adjust to hold the GPU
perfectly and tighten the screw. ** The bracket can also be installed in reversed when
using a thinner graphics card. Route the 12VHPWR cable as below in the dashed
arrow.
Do not use the NVIDIA adaptor cable, only use the 12VHPWR cable straight from
the PSU. GPU output cable routing. Reverse
mode**
GPU output cable routing. Cables graph for reference only, product are subject
to the actual product.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>