crow Runner D-Link USB Instructions
- June 13, 2024
- CROW
Table of Contents
crow Runner D-Link USB Instructions
General
The D-LINK USB adaptor use for direct connection between the CROW control panels (PowerWave, Runner) and a PC computer with Upload/Download Program (ULD/XLD).
Driver Installation
Before first time using the D-LINK USB, install the USB Driver on your PC computer.
Follow these steps for the USB’s Driver installation
- Use the Internet connection and download into your PC the USB driver from the following link: http://www.thecrowgroup.com/support-download.asp
- Save the file to your Desktop.
- Open the file into the default path: C:\SiLabs\MCU\CP210x\Windows_2K_XP_S2K3
- From the folder named: C:\SiLabs\MCU\CP210x\Windows_2K_XP_S2K3
- Run the file: (It might take about 60sec. to install) CP210xVCPInstaller
- After the installation is complete, connect the USB device.
- The computer automatically will find and install the device.
- If program does not start automatically look for the driver in the following folder: C:\Program Files\Silabs\MCU\CP210x\
Control Panel Connection
In order to connect the D-LINK USB to the control panel follow the following steps:
- Unscrew the 2 holding screws and remove the cover.
- Plug the adaptor to the control panel.
- Connect the small USB connector of the cable into the D-LINK USB adaptor.
- Plug the USB cable into the PC USB Socket.
- Start the Upload / Download program on the PC computer.
- On the tool bar open Communications >>Source and choose the right COM port.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>