hp M109e Laser Jet Printer User Guide
- June 13, 2024
- HP
Table of Contents
Reference Guide
HP LaserJet
M109e – M112e series
Control panel
Light patterns
| Ready
---|---
| Processing
| Initializing, cleaning, or cooling down
| Error, manual feed, manual duplex, cartridge very low, or out of paper
If blinking fast, press to continue
printing or to print the information page
For a complete list of light patterns, refer to user guide on: hp.com/support.
Printer features
1. Output bin
2. Cartridge access door
3. Front door and input tray| 4. USB port
5. Power connection
---|---
Do not use USB for setup
Printers with a label covering the USB port must be set up with HP Smart and
an Internet connection. After setup, you can print using a USB cable if
needed, but the printer must also
remain connected to the Internet. Remove the label to uncover the USB port
when needed.
Help and tips for Wi-Fi and connectivity
If the software is unable to find your printer during setup, check the following conditions to resolve the issue.
Potential Issue | Solution |
---|
Printer Wi-Fi setup mode timed out
| If the Wireless light is not blinking blue, the printer might not be in Wi-
Fi setup mode.
Restart setup mode:
1. Press and hold on the control panel until light starts blinking, and then
release the button.
2. Wait for the printer to restart.
3. Open the HP Smart app and add the printer. If needed, swipe right/left on
the top of the home screen to find the Add
Printer option.
Note: Only 2.4 GHz connection supported.
Computer or mobile device too far from printer| Move your computer or mobile
device closer to the printer. Your device might be out of range of the
printer’s Wi-Fi signal.
Computer connected to a Virtual Private Network (VPN) or remote work network|
Disconnect from a VPN before installing HP Smart software. You can’t install
apps from the Microsoft Store when connected to a VPN.
Connect to the VPN again after finishing printer setup.
Note: Consider your location and the security of the Wi-Fi network before
disconnecting from a VPN.
Wi-Fi turned off on computer (computer connected by Ethernet)| If your
computer is connected by Ethernet, turn on the computer’s Wi-Fi while setting
up the printer. You don’t need to disconnect the Ethernet cable.
Bluetooth and location services are turned off on your mobile device| If
setting up with a mobile device, turn on
Bluetooth and location services. This helps the software find your network and
printer.
Note: Your location is not being determined and no location information
is being sent to HP as part of the setup process.
Exclusive HP+ Support
Get complimentary support by
contacting our experts at this website.
Support varies by country/region. Visit website for more information.
https://www.hp.com/plus-support
The information contained herein is subject to change without notice.
© Copyright 2021 HP Development Company, L.P.
Printed in Vietnam
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>