SUNVOT GC600 5G CPE WiFi Router User Guide
- June 13, 2024
- SUNVOT
Table of Contents
GC600 5G CPE
Quick user guide v1.0
FCC Statement
Warning: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to operate
the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
The device must not be co-located or operating in conjunction with any other
antenna or transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC RF Radiation Exposure Statement Caution: To maintain compliance with the
FCC’s RF exposure guidelines, place the product at least 20cm from nearby
persons.
High power radars are allocated as primary users of the 5.25 to 5.35 GHz and
5.65 to 5.85 GHz bands.
These radar stations can cause interference with and/or damage this device. No
configuration controls are provided for this wireless equipment allowing any
change in the frequency of operations outside the FCC grant of authorization
for US operation according to Part 15.407 of the FCC rules
Overview
The GC600 CPE is a highly advanced LTE multi-service product solution
specifically designed to meet integrated data, voice and Wi-Fi access needs
for residential, business and enterprise users. The product supports advanced
networking, VOLTE gateway and WLAN AP functionalities.
It enables wide service coverage and provides high data throughput and
networking features to customers who needs easy broadband access, low-cost
VOLTE service and Wi-Fi connectivity.
Operator Device Specification
| Model | Description & User Interface |
|---|---|
| GC600 | • 1 1000Mbps LAN1 Port with 1LED indicator, 1* 1000Mbps WAN/LAN2 |
port with 1LED indicator
• 1 RJ11/FXS Port
• 1 Micro USB
• LED Indicators:SYS, WIFI, 4G, 5G
• 1 Power key, 1 WPS Key, 1 Reset hole
1 * DC Port, 12V/1.5A
Radio Interface Specification
| 5G Frequency Bands 5G Protocol | N7/N77/N78 |
|---|---|
| 5G Operation Mode | 3GPP Release 15 |
| 4G Frequency Bands | DL 4X4 MIMO, 256QAM |
| 4G Protocol | B2/4/5/7/28/66 |
| 4G Operation Mode | 3GPP Release 14 |
| Output Power | DL 2X2 MIMO, 256QAM |
| SIM Support | 23 ± 2dBm |
| SIM card slot (3FF) |
Wi-Fi Interface
| Radio Access | 802.11a/b/g/n/ac (2.4GHz 300Mbps, 5GHz 867Mbps) |
|---|---|
| Output Power | 2.4G 2×2 20dBm, 5G 2×2 23dBm |
| Antenna | built-in 4 omni-directional antennas, 2×2 2.4GHz 0-2dBi, 2×2 5GHz |
3dBi
Security| WPA / WPA2, WPA-PSK/ WPA2-PSK encryption, WPA3
Getting Started
- Packing list and CPE Unit
Upon receiving the product, please unpack the product package carefully. Each product is shipped with the following items:
Table. Packing List
| CPE Products | Quantity |
|---|---|
| CPE unit | 1 |
| 12V DC Power adapter | 1 |
| Ethernet Cable | 1 |
If you find any of the items is missing, please contact our local distributor
immediately.
Installing and power on
To power on the device, the CPE must use a 12V DC power supply adapter. The
power adapters can operate in 90-250V AC range and therefore can be used in
different country. For CPE with the SYS LED indicator, a solid light indicates
the system has completed the startup procedure. To connect PC, LAN switch or
other type of IP device to the CPE product, the user should use standard CAT6
Ethernet cable and connect to the appropriate LAN port.
To use the phone service, operator can simply plug the phone line to the CPE
RJ11 port in the back. If the line is not registered or configured, a fast-
busy tone will be provided. 
Insert SIM Card
LED Display
| Type | LED | Function | Description |
|---|---|---|---|
| GC600 | SYS | system indicator | Green – System is ready |
| WIFI | Wi-Fi indicator | Green – WiFi is on Off – WiFi is off | |
| 4G | 4G signal indicator | Green: Strong Signal, RSRP > -80dBm Yellow:Middle |
Signal, -80dBm > RSRP> -100dBm Red: Weak Signal, RSRP < -100dBm
Off:No login to 4G network, or not 4G signal
5G| 5G signal indicator| Green: Strong Signal, RSRP > -80dBm Yellow:Middle
Signal, -80dBm > RSRP> -100dBm Red: Weak Signal, RSRP < -100dBm
Off: No login to 5G network, or not 5G signal
Managing CPE Device
The GC600 offers rich management features which facilitate the task of service
provider. It supports local management access, Telnet, WEB, and centralized
remote OTA configuration, upgrades management via standard FOTA systems. The
following describes the basic procedures for configuring the device for
operation.
WEB Login
It is a preferred to setup the CPE using a Web browser from a local PC
connected to device LAN port. The operator should ensure that the connected PC
has acquired IP address via DHCP from the device. After IP connectivity is
established between the PC and CPE device, the operator may launch a Web
browser and specify http://192.168.1.1 in the address bar. A window will pop
up requesting password. Input the user login password and then click the “Log
in” button. After successful log on, the default home page of the WEB GUI
interface will appear. Note the default password is “admin”.
System Information
System Status
The menu shows the general system info of the CPE device. It includes system,
general, WAN, LAN, Wi-Fi information.
Network Setting includes settings for all access points, including 3/4/5G/Wi-
Fi
FAQ and Troubleshooting
| Problem | Suggested Solution |
|---|---|
| My PC cannot connect to theCPE. | • Re-plug the PC Ethernet cable and check if |
the PC LAN connection is up
or showing activity.
• Check if the CPE Power is on. If it is not, check the power cord and make
sure it is connected properly. Also verify that the AC power supply is
available.
My PC cannot acquire IP
from the CPE.| • First check if the Network card is up and working properly.
Then check
the PC Network card configuration and make sure the DHCP is enabled.
• To release and renew the correct IP address, please unplug the Ethernet
cable from PC and wait for about 5 seconds, then connect it again.
If the problem persists, please contact the operator or distributor for
further diagnose.
My CPE networking is not
working properly.| • You may want to check if the network connection is up and
running
properly. You can do this by login the WEB GUI and check the Interface
Info page.
• You may want to perform a factory reset and see if the problem is being
corrected. You can do this by log into the WEB GUI using “admin”
password and perform restore the unit to default factory setting.
• If the problem cannot be corrected by factory reset, please contact the
operator or distributor for further diagnose.
I forget the login passwordand like to reset the unit tofactory default.| •
User can hold the CPE RESET button for 10 seconds with power on to
clear and reset the unit to factory default setting.
• After the unit is reset to factory default, you can login using the default
password.
E-mail: Support@sunvot.com
Manufacturer：Ningbo Sunvot Technology Co., Ltd
Address： Building 3, NO 55 Longtan Shan Road, Beilun Daqi, Ningbo,
Zhejiang,China
Website: https://www.sunvot.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>