simplehuman PD6309 Rectangular Sensor Installation Guide
- June 13, 2024
- simplehuman
Table of Contents
simplehuman PD6309 Rectangular Sensor
Lid assembly PD6254
for ST2031 rectangular sensor can
Tools you need:
small flathead screwdriver
video guide
Removing Lid
-
Remove batteries or AC adapter from the sensor can.
Wave hand over sensor to make sure there is no power.
-
Open lid and liner rim and push back until it is locked into place.
-
Insert screwdriver between the lid and panel, then push the screwdriver down to unlock the panel.
-
Remove inner panel around the lid.
-
Unplug connector from the electronic board.
-
Unhook wire from its groove.
-
Use screwdriver to slide tabs toward the center. Make sure both tabs have been moved to their end-most positions.
-
Firmly grasp lid assembly and pull it upward.
Installing Lid
-
Remove inner panel from the new lid assembly. Place new lid assembly onto the sensor can in the open position.
-
Slide tabs outward using screwdriver. Start with the left side first. Tip: You may need to constantly adjust lid while sliding the right tab.
-
Hook wire through its groove.
-
Plug connector into the electronic board.
-
Place inner panel back into lid. Make sure panel snaps into place.
-
Close lid and insert batteries or connect AC adaptor.
Final Result
Customer Service
product questions or returns
customer.support@simplehuman.com
PD6254 | www.simplehuman.com | 121-0114-01
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>