viessmann 6338 Ceiling LED Spotlight Instruction Manual

: June 13, 2024
: VIESSMANN

Table of Contents

Important information
Introduction
Mounting
Connection
Technical data
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

**viessmann 6338 Ceiling LED Spotlight Instruction Manual

**

Important information

Please read this manual completely and attentively before using the product for the first time. Keep this manual. It is part of the product.

Safety instructions

Caution:

Risk of injury!
Due to the detailed reproduction of the original and the intended use, this product can have peaks, edges and breakable parts. Tools are required for installation.

Electrical hazard!
Never put the connecting wires into a power socket! Regularly examine the transformer for damage. In case of any damage, do not use the transformer!

Make sure that the power supply is switched off when you mount the device and connect the cables!

Only use VDE/EN tested special model train transformers for the power supply!

The power sources must be protected to prevent the risk of burning cables.

Using the product for its correct purpose

This product is intended:

For installation in model train layouts and dioramas.
For connection to an authorized model train transformer (e. g. item 5200).
For operation in dry rooms only.

Using the product for any other purpose is not approved and is considered inappropriate. The manufacturer is not responsible for any damage resulting from the improper use of this product.

Checking the package contents

Check the contents of the package for completeness:

Item 6338

1 ceiling spotlight
1 exchange console
Manual

Item 6339

7 ceiling spotlights
7 exchange consoles
Manual

Introduction

This model produces the light by SMD-LEDs which is suitable to the model. Low heat build-up and power input. Nearly unlimited lifetime of the LED, so no more change is required.

Mounting

Remove the ceiling spotlight carefully from the package.
Check the function before mounting.

Caution:
Installation and electrical wiring may only be carried out while the power supply is switched off.

Drill a hole of Ø 2 mm at the mounting place (fig. 1).
Put the cables from outside through the hole and fix the console, e. g. with a commercial glue.

Hint:

To mount the ceiling spotlight item 6338 to the kibri item 39000 bus terminal please exchange the fixed console (on the product) with the attached console (equipped with two pins). The console is a special construction for the kibri item 39000. The ceiling spotlights of the extension set item 6339 are mounted with the consoles on the kibri item 39000 bus terminal. Installation is explained in the manual of item 39000.

To mount reflectors item 6339 at other positions please exchange the consoles.

While connecting the cables, leave a loop of about 2 – 3 cm length below the model, so that you can pull and reverse the model from the mounting hole at any work.

Caution:
Resistor and diode at the cables are needed for proper function of the lamp. Never cut them off! Never cover the resistor with insulation material, because it has to be cooled by surrounding air!

Connection

Connect the LED-model to the lighting power output of a model train transformer (e. g. item 5200) or power supply as shown in fig. 3 and/or 4.

DC voltage: Connect the diode (red part with black marking) with the positive pole and the resistor with the negative pole of the power supply.

AC voltage: Operation with AC voltage could cause some flickering. We recommend to use the Viessmann power module, item 5215, which is sufficient for approx. 100 LED-lamps or -reflectors (fig. 4). Connect the cable with the diode to the brown output socket and the cable with the resistor to the red output socket.

Hint:
Perfectly fits kibri product item 39000 modern bus terminal Halle/Saale.