SHENZHEN JUNYE ELECTRONICS V80013HP Wireless Headphone User Manual
- June 13, 2024
- SHENZHEN JUNYE ELECTRONICS
Table of Contents
SHENZHEN JUNYE ELECTRONICS V80013HP Wireless Headphone
Product Information
The device is a portable electronic device designed for various applications. It has a playing time of approximately 6 hours and a charging time of approximately 2 hours.
The device complies with part 15 of the FCC Rules, ensuring that it operates within specific limits and does not cause harmful interference. It is designed to accept any interference received, including interference that may cause undesired operation.
The FCC warning states that any changes or modifications not approved by the responsible party could void the user’s authority to operate the equipment. Therefore, it is important to operate the device as per the provided instructions without making any unauthorized modifications.
The device has been evaluated and meets general RF (Radio Frequency) exposure requirements. This means it can be safely used in portable exposure conditions without any restrictions.
Product Usage Instructions
- Before using the device, ensure it is fully charged by connecting it to a power source using the provided charger.
- To power on the device, press and hold the power button located on the device until the indicator light turns on.
- To adjust the volume, use the dedicated volume buttons located on the device. Press the “+” button to increase the volume and the “-” button to decrease it.
- To play audio or media, connect the device to a compatible audio source using the provided cable or wireless connection method.
- Use the controls on the connected audio source to play, pause, skip tracks, or adjust other playback settings.
- To power off the device, press and hold the power button until the indicator light turns off.
- When not in use, store the device in a cool and dry place to ensure its longevity.
PRODUCT OVERVIEW
Product Parameters
| Model | veoo13HeodphonH | Use Distance | 10M |
|---|---|---|---|
| Version | VS.3 | Battery Capacity | 200mAH |
| Stand-by Time |
180hours
| Playing time| about 6 hours
Power Input| DCSV/200mA| Charging Time| about 2 hours
Pairing and Connection
- Keep the distance between the mobile phone and the headset within 1 m; the closer, the better.
- Press and hald the key “ ” for about 5 seconds, and then release it when the red and the blue lamps alternately blink. At this time, the headset has entered the paring mode.
- Enable the Bluetooth function of the mobile phone, search the Bluetooth equipment, select “V80013 Headphones” for paring and connection. After connection is successful, the blue indica ting lamp of the headset slowly blinks.
Notes:
If there is no BT connection within 5 minutes, the headphone will be powered off automatically After pairing iscompleted, the headset and the handset will remember eachother, without pairing
FCC
Label
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
FCC warning
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.