hansgrohe 26274000 Shower Pipes Instruction Manual

hansgrohe 26274000 Shower Pipes

Product Information:
The product mentioned in the user manual is a shower system called Vernis Blend Showerpipe. It is available in different models, such as Vernis Blend Showerpipe 200 1jet, Vernis Shape Showerpipe 230 1jet, Vernis Blend Showerpipe 240 1jet, and Vernis Shape Showerpipe 240 1jet. These models may have additional features like EcoSmart technology.

Product Usage Instructions

1. Safety Notes:
   • Always wear gloves during installation to prevent crushing and cutting injuries.
   • The product is designed for bathing, hygiene, and body cleaning purposes only.
   • Do not load the arm of the shower head with other objects.
   • Proper supervision is required when children or individuals with physical, mental,and/or sensory impairments use this product.
   • The product should not be used by individuals under the influence of alcohol or drugs.
   • Keep a safe distance between the shower and sensitive body parts,such as the eyes.
2. Installation:
   • Refer to page 32 of the user manual for detailed installation instructions.
3. Maintenance:
   • Refer to page 42 of the user manual for information on maintenance procedures.
4. Flow Adjustment:
   • Refer to page 33 of the user manual for instructions on adjusting the flow.
5. Thermal Disinfection:
   • Refer to page 34 of the user manual for instructions on thermal disinfection.
6. Cleaning:
   • Refer to page 36 of the user manual for cleaning instructions.
7. Troubleshooting:
   • If there is insufficient water pressure, check if the supply pressure is adequate.
   • Clean the filter screen of the control unit if it is dirty.
   • Clean or replace the seal gasket between the showerhead and the hose.
   • Check if the thermostat has been properly adjusted.
   • Ensure that the warm water temperature is set appropriately.
   • If using a water heater, ensure it is functioning properly.

Please consult the user manual for further information and instructions on specific models and features.

Safety Notes

• Gloves should be worn during installation to prevent crushing and cutting injuries.
• The product may only be used for bathing, hygienic and body cleaning purposes.
• The arm of the shower head is intended only to hold the shower head. Do not load it down with other objects!
• Children as well as adults with physical, mental and/or sensoric impairments must not use this product without proper supervision. Persons under the influence of alcohol or drugs are prohibited from using this product.
• Do not allow the streams of the shower touch sensitive body parts (such as your eyes). An adequate distance must be kept between the shower and you.
• The product may not be used as a holding handle. A separate handle must be installed.
• The hot and cold supplies must be of equal pressures.

Installation Instructions

• Prior to installation, inspect the product for transport damages. After it has been installed, no transport or surface damage will be honoured.
• The pipes and the fixture must be installed, flushed and tested as per the applicable standards.
• The plumbing codes applicable in the respective countries must be observed.
• The installation dimensions stated in these installation instructions are ideal for people of approximately 1800 mm in body height. The dimensions can be altered if required. In this case, pay attention to the fact that a change of installation height will also change the minimum height, and that the altered mounting dimensions must be taken into consideration.
• During installation of the product by qualified trained personnel, make sure that the entire fastening surface is even and smooth (no protruding seams or tile offset), that the finish of the wall is suitable to apply the product and has no weak points.
• The premounted dirt collection screen must be used to prevent dirt from entering through the pipes. Dirt entering can affect the function and/or lead to damage to the functional components of the fitting. Hansgrohe will not be held liable for any resulting damage.
• The product is not designed to be used with steam baths!
• If the continuous water heater causes any problems, or you have different water pressures you must install a water limiter to the cold supply, (ordered separately,article number 97510000).

Technical Data

• Operating pressure: max. 1 MPa

• Recommended operating pressure: 0,1 – 0,5 MPa

• Test pressure: 1,6 MPa
  (1 MPa = 10 bar = 147 PSI)

• Hot water temperature: max. 60°C

• Centre distance: 150±12 mm

• Connections G 1/2: cold right – hot left

• Safety against backflow

• The product is exclusively designed for drinking water!

Symbol Description

Do not use silicone-containing acetic acid!

Safety Function

The desired maximum temperature for example max. 42º C can be pre-set thanks to the safety function.

Assembly

Adjustment

After the installation, the output temperature of the thermostat must be checked. A correction is necessary if the temperature measured at the output differs from the temperature set on the thermostat.

Thermal disinfection

Thermal disinfection pursuant to process sheet DVGW W 551 (≥ 70°C / > 3 min) must only be carried out by qualified personnel.

Maintenance

• The check valves must be checked regularly according to EN 806-5 in accordance with national or regional regulations (at least once a year).
• To guarantee the smooth running of the thermostat, it is necessary from time to time to turn the thermostat from total hot to total cold.

Dimensions

Flow diagram

(see page 38)

1. Overhead shower
2. Hand shower
3. Bath Spout

Spare parts

Special accessories

order as an extra

• tile-matching-disk #93813000; 93813670
• pipe 845 mm #93906XXX; #93906670
• pipe 945 mm #93770XXX; #93770670

Cleaning

www.hansgrohe.com/cleaning-recommendation
www.hansgrohe.com/cleaning-recommendation
www.hansgrohe.com/cleaning-recommendation
www.hansgrohe.com/cleaning-recommendation

Just clean: simply rub over the spray nozzles to remove lime scale.

Operation

To empty the overhead shower after use, hold it in a slightly inclined position.

Test certificate

Hansgrohe · Auestraße 5 – 9 · D-77761 Schiltach · Telefon +49 (0) 78 36/51-1282 · Telefax +49 (0) 7836/511440
E-Mail: info@hansgrohe.com
Internet: www.hansgrohe.com

References

• Taps for bathrooms, showers and kitchens | hansgrohe INT
• Web Server's Default Page
• Taps for bathrooms, showers and kitchens

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>