legrand WNREZK10WH Easy 3 Way Switch Kit Installation Guide
- June 13, 2024
- Legrand
Table of Contents
legrand WNREZK10WH Easy 3 Way Switch Kit
INSTALLATION INSTRUCTIONS
Expand your Easy Kit
You can easily add additional wired or wireless smart with Netatmo switches,
dimmers, and outlets to your pre-paired Easy Kit without the need for the
gateway.
NOTES
- Add any combination of up wired/wireless devices up to 20.
- Devices must be 30ft. or less from nearest wired device.
Step 1: Prepare New Devices
Wired devices: Wire and power all hardwired devices you wish to add to your
pre-paired Easy Kit per installation instructions in box. LEDs on wired
devices you wish to add will be solid red when powered.
Wireless devices: Install on flat surface or over wall box per installation
instructions in box. DO NOT remove battery tabs yet.
Step 2: Open Network
Press & release the EZ setup button on the wired device that came with your
pre-paired Easy Kit. LED will turn solid orange.
Note: You will need to remove the wall plate & subplate to access the EZ setup
button.
Step 3: Adding Wireless Devices
(skip to step 4 to add hardwired devices)
Pull battery tab from wireless device you are going to add. Press & release
the wireless device’s ON or OFF paddle once to pair it. LED on device will
briefly flash green, then turn orange, then go off.
Note: All wireless switches or dimmers added will act as group controllers,
controlling ALL lights connected to any of the wired smart
switch/dimmer/outlet.
Step 4: Adding Hardwired Devices.
(if no hardwired devices, skip to step 5)
Press & release the EZ setup button on device you are going to add. LED on
device will briefly flash green, then turn solid orange.
Note: All wired switches, dimmers, outlets, and plug-ins added will ONLY
control the individual load wired to or plugged into it.
Step 5: Close Network
Press & release twice the ON and OFF paddles on the wireless switch
simultaneously, pressing and releasing 2 times consecutively. LEDs on all
devices will go off.
Step 6: Test Your Device
For wireless switches, push on paddle to ensure load(s) is turning on.
For outlets/plug-ins, plug lamp into outlet marked controlled. Using wireless
switch connected to outlet, press on paddle to control lamp on/off.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>