TradeShowBooth com QuickZip MAX Curved Display Instruction Manual

Table of Contents

INCLUDED:

Curved Display

Assemble the Frame
Connect the poles by matching up the numbers. Insert center support pole into the middle of curved poles.
Install the Graphic
Carefully pull the graphic print over the frame, from left to right, pulling both sides along evenly.
Attach LED Lights (Optional)
Attach light clips to the frame (knobs facing back) and tighten until secure. Slide LED lights into the top grooves.
Align the Display
Stand up the frame and shift or wiggle the corners until it’s aligned and standing upright. Plug in your lights and your display is ready for action!

BOX CONTENTS

Assemble the Frame
Connect the poles by matching upthe numbers.
Install the Graphic
Carefully pull the graphic print over the frame, ensuring both sides are pulled down at the same time.
Attach Header to Backdrop
Place the backdrop display flat on the floor, align the header above the backdrop and attach the clamps between the frames.
Align the Display
Carefully lift the frame and Header back to an upright position. Your display is ready for action!

BOX CONTENTS – WATERFALL HARDWARE

BOX CONTENTS – TV MONITOR HARDWARE

Assemble the Frame
Using the numbers on the frame, connect the poles together.
Attach Crossbars
Connect both sides together by using the crossbars. Connect both the top and bottom end poles.
Install the Graphic
Carefully pull the graphic print over the frame, ensuring both sides are pulled down at the same time.
Install Shelves
Attach the clamps to the frame at the desired height, and twist the knob until secure. Then slide the shelves onto the the side ridges of the clamps.
Attach TV Mount
Screw the TV Mount on the Waterfall using the TV Mount Screws and metal washers.
Attach Brackets to Monitor
Attach the brackets on your monitor using the M5, M6, or M8 TV Bracket Screws.
Attach to Backdrop
Use the Top connector piece to attach the Waterfall to the Backdrop frame.
Attach Monitor to Stand
After the Waterfall is securely attached to the backdrop, connect the monitor to the monitor mount.

BOX CONTENTS

Assemble the Frame
Place Case Shell A on the floor and securelv insertthe poles into the four holes. Then align Case Shell B over the four poles, match up the holes, and fit securely into place.
Install the Graphic
Starting at the base, wrap the graphic around Case Shell A and pull up over the top of Case Shell B, one corner at a time. Adjust the graphic so it’s straight, then zip the back.
Attach the Counter Top
Place the black Counter Top piece on top and press down to ensure the grooves fit over the edges of the case shell.
Store Personal Items
Hide samples, marketing materials, or personal items inside the podium by storing under the case lid or within the zipper compartment in the back. Your Podium is ready for action!

Read User Manual Online (PDF format)