SHARP KP-B16S Electric JAR Pot User Manual

: June 13, 2024
: Sharp

Table of Contents

Thank you
SAFETY INSTRUCTION
INSTRUCTION FOR USE
DESCRIPTION OF PARTS
SPECIFIC INFORMATION
HOW TO USE
CLEANING AND MAINTENANCE
EARTH WIRE ASSEMBLY
EXCHANGE PACKING
Read User Manual Online (PDF format)
Download This Manual (PDF format)

SHARP KP-B16S Electric JAR Pot

Please see the date of manufacture marked on the product

Thank you

Thank you for your trust in products of Thai City Electric Co., Ltd. In order to use electric jar pot in efficiency way. Please read the instructions manual carefully before using this appliance.

SAFETY INSTRUCTION

Please read the warning and instruction for use carefully before using this appliance and comply strictly for your own safety and to prevent the damage that may occur on your property.

WARNING

Before connect the magnetic plug to body examine if anything stuck with it, remove before plugging.
Insert the plug into the wall outlet firmly and when disconnecting, hold the plug and pull it out without touching the power cord.
Do not Immerse the set in water,It may Cause electric leakage or damage of the electric jar pot.
Do not put cubes or pour milk, mineral water, liquor, tea and tea leaves, herbs or other liquid into the inner pot other than clean water for use. The pipe of the electric jar pot may be clogged.
Do not put the electric jar pot on the edge of table as it may fall down and cause damage.
Do not put the electric jar pot on a wet floor, under direct sunlight or near the gas stove.
Do not cover the steam outlet with a towel etc. Otherwise the hot water may spill or the share of the lid may change.
Do no pour hot water while boiling because splashing hot water may cause burn.
Do not touch the steam outlet with your hand may cause burn.
Never connect the plug with your wet hand as it may be dangerous from electric leakage.

INSTRUCTION FOR USE

Keep out of reach of infants and children as they get scald when the electric jar pot is tipped over and hot water spills out, or when the child suck at the spout.
In case the power cord is broken, it must be replaced with specialized power cord or the standard power cord made by manufacturer or appointed service providers
Avoid using disassemble or repair the electric jar pot by yourself. It may cause trouble such as a fire or electric shock. Consult your nearest dealer.
This appliance is intended to be used in household and similar applications such as.
– Staff kitchen areas in shops, offices and other working environments;
– Farm houses;
– By clients in hotels, motels and other residential type environments;
– Bed and breakfast type environments.
Move the electric jar pot by handle only and unplug the power cord
Avoid using fill water above the “Full” level, the water may spill out from the spout when boiled.
Avoid using boil water below the “Refill” level, it may lead to damage.Add some more water to “Full” level.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be suspense to ensure that they do not play with the appliance.
Close lid firmly, otherwise hot water outflow so much when tumbling.
Avoid using opening the lid when during boiling because touched hot steam.
Often examine the power supply cord, the defective power supply cord or plug may cause burning fire or electric shock.
Avoid using the electric jar pot for defrosting frozen food.

DESCRIPTION OF PARTS

SPECIFIC INFORMATION

MODEL| KP-B16$| |
---|---|---|---
Capacity (Max.) (£)| 1.6| |
Rated voltage (V)| 220
Rated frequency (Hz)| 50
Power consumption (W)| 610| 670
Electric current (A)| 2.77| 3,05
Pouring system| Manual air pressure operation
Outside dimension
0f’,/x H x D) (mm.)| 202 x301 x258| 202x383x258| 202x439x258
Weight (kg)| 1.6| 1.8| 1.9
IP number| IPXO

*Detail is subject to change without prior notice.

HOW TO USE

Be sure that the rated voltage is 220V only before use.
For the first use, boil water and pour out by pushing down the push button many times to let hot water out through spout. Then pour out the remaining water, carefully clean inner pot and lid.

Fill the inner pot with water

the Pour/Stop button at STOP positions.
Pushing the latch knob to open the lid.
Pour water within the range of “Full” level and do not splash water to the body.
Push down the lid until a “click” sound is heard.

Boiling water and keeping warm

Connect the magnetic plug to body.
(Be sure that it is firmly connector) .
Insert the other end of the plug into the wall out let.
When the plug is inserted into the wall outlet, the “BOIL” indicator lamp Cu) lights up, then electric jar pot starts boiling.
When boiling is over the “BOIL” indicator lamp goes off and change to “WARM”. The electric jar pot automatically change over to keep water hot as long as power is connected.The average temperature of hot water is 90 ·c, then gradually goes down to 85°C thus the “WARM” and the “BOIL” indicator lamp mutually lights up and go off depending on the thermostat.
Note
• Color of inner pot may be changed depending on water quality. Use clean water.
• Sounds are emitted during the boiling and warming. But this is quite normal.

Pour hot water

Set the Pour/Stop button at “POUR” – position and push down the push button to pour hot water.
After pouring hot water, set the Pour/Stop button at “STOP” position.

AFTER USING

Disconnect the plug from the wall outlet.
Rinse the inner pot with water, if the water is left in the inner pot,it may collect water deposit and cause corrosion.

REMOVING THE LID

Push the latch knob found in the front part 0( ~ of the lid, then open the lid up to 60 C
Shift the lid forward, and lift it up, then it – can be detached.

CLEANING AND MAINTENANCE

When not using the pot for a long period

body upside down wipe off moisture in the inner pot well. If the water is left in the inner pot, it may collect water deposit and cause corrosion.

How to Cleaning

Before cleaning, be sure to disconnect the plug, pour out the remaining water and cool down the body. Do not use polishing powder, hard brush, thinner, alcohol or other solvent, otherwise the surface may be damaged or discolored.

Body, lid and handle soak a soft cloth in water, squeeze properly and wipe carefully.
Inner pot should be cleaned every week by soaking a sponge with water. Then rub the inside of the inner pot carefully. Rinse and drain sufficiently with water.

When the inner pot was discolored due to different water Quality

Mix vinegar with (1 :1), pour the mixer water up to the “Full” level of the inner pot and let it boils.
After boiling, let it stand for one hour, then pour out the vinegar.
Soak a sponge with water and rub the inside of the inner pot carefully. The rinse thoroughly with water until vinegar smell goes out.
After cleaning. fill water up to “Full” level and let it boils, then pour out the water as usual before regular use

EARTH WIRE ASSEMBLY

Remove magnetic plug before assembly earth wire.
Remove the screw for earth wire about 2-3 mm. (Symbol ) and insert earth wire assembly and fasten washer for earth wire.

For safety, please connect ground wire.
If the installation of ground system is required, please contact electrician or customer service agent.
Do not connect ground wire to gas pipe, water pipe, telephone line or lighting conductor.

EXCHANGE PACKING

Loosen 3 screws holding the inner lid.
Pull the inner lid packing off from the inner lid.
Renew the inner lid packing, be sure of the proper side that fits the inner lid
Assembled in the same manner that you removed

Note
Inner lid packing has a life-time of use. When it is over, pouring water out may be impossible. Inner lid packing exchange is a service.
THE SPECIAL FEATURE

This is a combination of water bottle and warmer, with clean and sanitary stainless steel construction.The water volume can be checked at a glance on the easy-to-read water level indicator.

MANUFACTURED BY FEDERAL ELECTRIC CORP., LTD.
64/1 Moo 4 Kingkaew Rd., Rajatheva, Bangplee, Samutprakarn 105 Sole Distributor in Thailand

THAI CITY ELECTRIC co., LTD.
1643/4 New Petchburi Rd., Makkasan, Ratchathewi ·
E-mail: callcenter@thaicily.co.th
Bangkok 10400Tel. o 2333 3111Call cen1er o 2254 sooo
www.thaicity.coth
www.sharp-weeclub.com