flashbay DT2201 Duet Bluetooth Earphones User Manual

flashbay DT2201 Duet Bluetooth Earphones

OVERVIEW

• A Multifunction button. See below for all functions
• B LED light. Red: Charging in case.
  • LED turns off once fully charged
• Red & Blue flashing: Pairing
• Blue flashing: Paired
• C Audio output
• D Charging contact points
• E Charging case battery indicator.
• F USB-C charging port.
• G Charging case

Turning on

• The earphones will automatically turn on when you take them out of the charging case. You can also turn on the earphones by pressing and holding button for 3 seconds

Pairing

1. Ensure that Bluetooth is activated on your phone, tablet or other device.
2. With the earphones out of the charging case, the LED lights will flash red and blue alternately, the earphones are now in pairing mode.
3. On your device, select “Promo Audio” or Custom Device Name to pair.
4. The LED light will flash blue once successfully paired.
5. The earphones will then automatically connect to your preferred device when turned on again.

Unpairing

You can unpair the earphones from your device via any of the below options:

1. Put the earphones back in the charging case
2. Disconnect via your device’s Bluetooth ® settings menu.
3. Selecting ‘Forget Device’ via your device’s Bluetooth ® settings menu.

Play / Pause

• Press button on either earphone to play and pause music.

Skip Songs

• When playing music, press button three times on either earphone to skip the song.

Volume Control

• Press button twice on the left earphone to increase the volume. Press button twice on the right earphone to decrease the volume.

Activate Siri for iPhone users

• Hold button on either earphone for 2 seconds to activate Siri.

Call answering and Call hang up

• Press button on either earphone to answer a call. You can then press button again to hang up.

Reject a Call

• Press and hold button fA or 2 seconds on either earphone to reject an incoming call.

Low battery prompt

• When the battery is running low, a ‘low battery tone’ will be played every 30 seconds until the earphones are powered off or placed in the charging case.

Turning off

• The earphones will automatically turn off when you place them into the charging case. You can also turn off the earphones by pressing and holding butto An on either earphone for 5 seconds.

Charging the case

1. Connect the USB-C cable to a power source and then plug the USB-C cable into the USB-C port on the side of the charging case. The max input voltage and current should not exceed 5V and 200mA respectively.
2. The charging case will take approximately 2 hours to be fully charged.
3. The battery indicator light on the case flashes red while charging and stops flashing when fully charged.

Charging the earphones

1. Place the earphones into the charging case, ensuring that the connection points are in contact.
2. The LED on the earphones will show a static red light whilst the earphones are charging.
3. The red LED light will turn off once the earphones are fully charged.
4. The earphones will take approximately 1 hour to fully charge.
5. The battery indicator blue light will be on when charging the earphones and will turn off when the battery is empty.
   • The charging case battery status will be indicated as below

   • 3% Blue light on

   • <3% Blue light flashing
   • 0% Blue light off and stop charging earphones.

Safety and Compliance Information

• Do not attempt to disassemble the product or insert items into the product as this may cause short circuits resulting in electrical shock or fire.
• The product contains no user replaceable parts. Only authorised service engineers may open the product.
• This product is not waterproof or water resistant. Exposing the product to rain, moisture or other liquids may damage the product and may result in injury to the user. Do not touch or use with wet hands.
• Do not use in areas where there is the risk of explosion.
• The product package contains small items and packaging that may be hazardous to children and may pose a choking or strangulation hazard. Keep the product, accessories and packaging out of reach of children at all times.
• This product is not a toy If the product is damaged in any way, pierced, dropped, exposed to liquid, if the product overheats or if the charging cable is damaged discontinue use immediately.
• Do not connect to any input power supply other than stated at the top of this page. Always keep the product between 0°C and 45°C. Operation outside this range may damage the product or cause harm to the user.
• CAUTION: The battery used in this product may present a risk of fire, explosion, electrical shock or chemical burn if mistreated.
• The battery in this product is not user replaceable and should only be handled by authorised service engineers.
• Only use the charging cables provided with the Earphones and the charging device, do not charge with other cables.
• Do not dispose of the product in household waste as this may result in fire, explosion, electrical shock or chemical burn.
• Under certain conditions, exposing the device to a strong electrostatic discharge may cause the device to stop operating. Resulting in the need to reset.

FCC Statement

ISED Statement

This device contains license-excempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development
Canda’s license-excempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.

The SAR limit of Canada (ICES) is 1.6 W/kg for head averaged over one gram of tissue. Device types Bluetooth Earphones ANC (IC: 22713-DT2201) has also been tested with 0mm against this SAR limit.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference
2. this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Please remove the batteries safely with appropriate tools when disposing of the earphones or batteries. Please use designated collection or recycling facilities.
To comply with RF exposure requirements, a minimum separation distance of 0mm must be maintained between the user’s body and the Bluetooth Earphones, including the antenna. Body accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna. The maximum results of Specific Absorption Rate (SAR) found during testing for Duet are 0.034W/kg
FCC ID: 2ALRV-DT2201
IC: 22713-DT2201
Note:The FCC ID: 2ALRV-DT2201 is only for the earphone(not charging case).
And because the Bluetooth® Earphones are too small, the FCC ID number can only be printed on the charging case.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>