Corbett Lighting 437-30-VGL Aura Wall Light User Guide
- June 13, 2024
- Corbett Lighting
Table of Contents
LIGHTING GROUP
Hudson Valley Lighting
Troy Lighting
Mitzi Corbett Lighting
437-30-VGL Aura Wall Light
WARNING/CAUTION
- DISCONNECT POWER BEFORE RE-LAMPING OR WIRING THE FIXTURE. READ ALL INSTRUCTIONS COMPLETELY BEFORE STARTING INSTALLATION.
- TO AVOID THE RISK OF FIRE OR SHOCK, FIXTURE MUST BE INSTALLED IN COMPLIANCE WITH ALL APPLICABLE NATIONAL AND LOCAL ELECTRICAL/BUILDING CODES. THE INSTALLATION AND MAINTENANCE OF THIS UNIT SHOULD BE COMPLETED BY A LICENSED ELECTRICIAN OR CERTIFIED FACTORY TRAINED TECHNICIAN.
- CALIFORNIA PROP 65: THIS LIGHTING FIXTURE CONTAINS CHEMICALS KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER, BIRTH DEFECTS, AND/OR OTHER REPRODUCTIVE HARM. WASH HANDS AFTER USE.
- UNPACK FIXTURE, PARTS AND PARTS BAG(S) BEFORE DISCARDING THE CARTON. MAKE CERTAIN THAT ALL PARTS ARE FOUND. INSPECT THE FIXTURE PRIOR TO INSTALLATION FOR ANY DAMAGE. HVLG DOES NOT PAY OR REIMBURSE ELECTRICIAN FEES. FIXTURE MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED. SEE WARRANTY FOR EXCEPTIONS.
- PLEASE CLEAN WITH A SOFT, DRY CLOTH ONLY! DO NOT USE CLEANSERS.
CORBETT
AURA
437-0
Installation instructions
FIXTURE INSTALLATION
- Attach the MOUNTING PLATE (B) unto the junction box using the MOUNTING SCREWS (D). This fixture is designed to be mounted on standard round or octagon junction box. The junction box must be securely mounted to the structure of the building.
- Attach the Ground wire (Green) to the ground inside the outlet box (Generally green or bare copper wire) or the GROUND SCREW (C) on the MOUNTING PLATE (8). NEVER CONNECT GROUND WIRE TO “HOT” WIRE! FAILURE TO FOLLOW THIS COULD RESULT IN SERIOUS INJURY OR DEATH!
- Connect the white fixture lead to the neutral (Generally white) wire in the outlet box. Fasten the wires together with on approved fastener (WIRE NUT) (A). Starting I° below the fastener, tightly wrap the connection with electrical tape so that the connections seats the end of the fastener. MAKE SURE THERE ARE NO EXPOSED WIRE OF STRANDS THAT COULD CAUSE A DANGEROUS SHORT CIRCUIT!
- Connect the black fixture leads to the hat (Generally black) wire in the junction box. Fasten the joined wires same as previous step. NEVER REVERSE HOT AND NEUTRAL WIRES. FAILURE TO FOLLOW THIS COULD RESULT IN SERIOUS INJURY OR DEATH!
- Attach the FIXTURE ASSEMBLY (F) to the MOUNTING PLATE (8) using BALL NUTS (E).
- 6 Put the BULB (G) into the SOCKET of the FIXTURE ASSEMBLY (F).THIS FIXTURE IS RATED FOR 4 WATT G9 (LED BULB). DO NOT EXCEED THE RECOMMENDED WATTAGE!
- Attach the TOP FINIAL(G) and BOTTOM FINIAL(I) of the sconce.
- Restore power to the outtet at the breaker or fuse box.
PART(S) | REPLACEMENT PART NAME | PART NUMBER |
---|---|---|
A,B,C,D | HARDWARE KIT | HDW-437-30 |
E | BALL NUT | NUT-437-30 |
G | TOP FINIAL | FIN-437-30-A |
BOTTOM FINIAL | FIN-437-30-B |
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>