BLACKZON Scale 4WD Electric Monster Truck Instruction Manual

1/12TH SCALE 4WD ELECTRIC MONSTER TRUCK
INSTRUCTION MANUAL

Thank you Merci
Thank you for selecting this Blackzon RC product! HAVE FUN! But please read this first !!
We know you will have great fun with your model, but to get the best from your purchase please read this information BEFORE you operate the model.

**** Safety precautions

This product is an authentic radio controlled vehicle (RC vehicle) and it is not a toy. Read and understand this instruction manual thoroughly before running the model. If you are not familiar with RC vehicles, we recommend that you ask someone familiar with RC vehicles for advice.
Never connect the rechargeable drive battery in the reverse polarity or disassemble the battery. If the drive battery is used in the wrong way, high current can be generated and it is very dangerous.
Never run RC models near people or animals, or on public streets or highways. This could cause serious accidents, personal injuries, and/or property damage.
Make sure the mains power socket when using a charger is readily accessible and never left plugged in when not in use.
If you are using Rechargeable AA’s for the Transmitter please make sure you also purchase a suitable charger for this battery type.

Equipment Needed

2x AA Batteries for Transmitter
Components

Decal Application

Transmitter Information

1. Steering Wheel
2. Trigger
3. Steering Trim
4. Speed Switch
5. Steering Reverse Switch
6. Power Indicator
7. Power Switch
8. AUX. Button
   (This button is disabled for this car)

Open the battery holding tray to expose the empty battery slots.
Insert 2 AA batteries into the marked spaces.
Please note the correct direction of the batteries Incorrect battery insertion could damage the transmitter.

1. Power Switch Socket
2. Plug for LED Lights
3. Plug for LED Lights
4. Servo Plug Socket
5. Antenna
6. Power Indicator

Charging Battery

Cautions

Only use the included charger to charge the battery pack.
– Always disconnect the battery from the ESC and remove it from the vehicle when you are not using it.
– Please fully charge the battery before each use.
– Do not leave the battery uncharged for a long time.
– Do not fully discharge the battery while driving the vehicle. Do not charge the battery in wet or humid conditions. Charge only in dry conditions.
The USB Charger requires a USB Adaptor with an output of at least 2A (Not included)

1. Connect the charging socket to the supplied battery packs power plug. The connectors are sided and have a clip to secure it in place.
   Do not force together and always check you have the connection the right way round.

2. The charger will automatically start to charge your battery pack.
   The USB charger has Delta-Peak and will stop charging when it detects the battery pack is at full charge.
   *Error: Voltage out of charging range. If this is reoccurring your battery pack may be damaged and need replacing.
   

Getting Started

1. Turn on Switch
   Turn on transmitter first and then turn on receiver.
   Turn on the transmitter switch and the LED battery indicator will light up.
   Turn on the receiver. Press and hold for 2-3 seconds to switch on.
   The Red LED will show if the installed AA batteries have sufficient charge.
   The Red LED will flash if the batteries need replacing.

2. Transmitter Operation

3. Steering Trim Setup Turn steering trim to set tires in completely centered position.

4. Speed Switch Gaslimiter The speed switch is a throttle limiter. Turning the switch all the way downreduces the top speed to 40% of maximum speed. Turning the switch upincreases the speed up to 100%.

5. Steering Reverse Switch If the vehicle turns right when you steer left and turns left when you steer right, flip the “Steering Reverse” switch.

6. Turning R/C Unit Off
   Turn off receiver first, then turn off transmitter.
   If you switch off the transmitter first before the R/C car, you may lose control of the R/C car.
   Press and hold for 2-3 sec. to switch off

Headlight Installation

1. The headlights are included in the box and not installed on the car.
2. Take out the headlight, the zip ties, and the adhesive tape from the box.
3. Apply the adhesive tape to the headlight board and stick it on the upper deck as shown in Photo 1.
4. Gently insert the headlights into the slots on the back of the front bumper. Make sure they are securely in place.
5. Insert the headlight plug into the slot on the ESC/Receiver. (See Photo 2)
6. Arrange the wires and bind them up with the aid of the zip ties.

Maintenance after driving

Proper maintenance is very important. After running, clean the chassis and check all moving parts for damage. If any parts are broken or damaged, repair or replace them before the next run. Regular maintenance is necessary to prevent damage to the car and maintain its performance.
Completely remove all dirt and debris from the vehicle, especially in the suspension, drive shafts and steering parts. Inspect each part and screws for loosening, missing parts or damages.

Trouble Shooting

A.The vehicle does not work at all:

1. Check to ensure that radio controller and car are switched on.
2. Check if there are damaged parts/wires/connectors, repair or replace if necessary.
3. Car battery is flat. Charge the battery pack.

Parts List

Exploded View

Guarantee

90 Day Component Guarantee
This product is covered by a 90 day component guarantee from date of purchase. If any part of the product fails as a result of faulty manufacture during this period then we will repair or replace that part at our discretion.
We do not operate a new for old guarantee once the product has been used.
Please note this product is not a toy and it is recommended that children 14 and under are supervised by an adult. It is the responsibility of the parent or guardian to ensure minors are given appropriate guidance and supervision.
If you suspect there is a problem with the product, for whatever reason, it is the user’s responsibility to investigate and take steps to rectify the problem before further damage occurs.

Legal Information

Do not dispose of electrical components in household waste.
**** The radio equipment type in this product transmits within the frequency range 2.4 to 2.485 GHz with a maximum power of 20dBm and is in compliance with EU Directive 2014/53/EU. The full text of the Declaration of Conformity is available at http://ce.blackzon.com/

FCC Compliance:
This device transmits within the range 2.4 to 2.485 GHz and has been tested to comply with the limits for a Part 15 Class B device of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. Any change or modification to the device not expressly approved by the manufacturer may void the user’s authority to operate the equipment. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

HPI RACING A/S
Jegindoevej 21
8800 Viborg, Denmark
WWW.BLACKZON.COM

References

• Legetøj, spil og fjernstyrede biler – Alt i hobby artikler

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>