tp-link EAP113 Outdoor Access Point Installation Guide

: June 13, 2024
: tp-link

Table of Contents

Typical Network Topology
Hardware Connection
Hardware Installation
Safety Information
Warranty
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

tp-link EAP113 Outdoor Access Point

Note: The image may differ from the actual product.

Typical Network Topology

Managed Mode

Via Centralized Management Software

Typical Network Topology

A computer running the centralized management software, which can be in the same or different subnet with the APs, is used to centrally manage the APs.
You can get the corresponding software from our website http://www.tp- link.com.

Via Hardware Controller (For certain devices)

Typical Network Topology

The hardware controller can be in the same or different subnet with the APs. The management host is used to log in to the hardware controller to centrally manage the APs.

Standalone Mode

Typical Network Topology

Hardware Connection

Choose a method to connect your device according to the accessories.

Via PoE Switch

Some APs can be powered via the PSE device (such as a PoE switch) which complies with Power Source Class 2 (PS2) or Limited Power Source (LPS) of IEC 62368-1.
Note: Availability depends on the actual product. Please refer to the product specifications.
Hardware Connection

Via PoE Adapter

Some APs can be powered via the PoE adapter.
Note: Availability depends on the actual product. Please refer to the product specifications.
Hardware Connection

Or

Hardware Connection

Hardware Installation

Choose a method to mount the device.
Mounting the Device on a Pole
At the selected site, attach the device to a suitable point of the pole and then approximately align the device to the direction that you have oriented.

Mounting the Device on the Wall (for the product with mounting brackets)
Mount the mounting bracket to the preferred position in the wall. Push and slide the device to lock it into place. Then connect the antennas to the device.
Install the waterproof seal. (For certain devices) Before installing, fit the Ethernet cable through the spiral cover, bracket, and O-ring. Then follow the steps as shown in the picture:
Connect the Ethernet cable to the port.
Fit the O-Ring to the head of the bracket, and the bracket to the body of the device.
Fit the Ethernet cable through the seal’s slit with the thicker side towards the bracket.
Plug the seal to the bracket.
Screw the spiral cover to the bracket.

Safety Information

Keep the device away from fire or hot environments. DO NOT immerse in water or any other liquid.
Do not attempt to disassemble, repair, or modify the device. If you need service,please contact us.
Do not use damaged charger or USB cable to charge the device.
Do not use any other chargers than those recommended.
Do not use the device where wireless devices are not allowed
Adapter shall be installed near the equipment and shall be easily accessible.
Adapter should be used indoors where the ambient temperature is lower than or equal to 40 ℃.
The plug on the power supply cord is used as the disconnect device, the socketoutlet shall be easily accessible.

Please read and follow the above safety information when operating the device. We cannot guarantee that no accidents or damage will occur due to improper use of device. Please use this product with care and operate at your own risk.

TP-Link hereby declares that the device is in compliance with the essential requirements and other relevant provisions of directives 2014/53/EU, 2009/125/EC, 2011 /65/EU, (EU) 2015/863.

The original EU declaration of conformity may be found at https://www.tp- link.com/support/ce/.

Warranty

For TP-Link Branded Products Only. For the information about warranty period, policy and procedures, please visit https://www.tp-link.com/en/support

THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY HAVE OTHER RIGHTS THAT VARY FROM STATE TO STATE (OR BY COUNTRY OR PROVINCE).
TO THE EXTENT ALLOWED BY LOCAL LAW, THIS WARRANTY AND THE REMEDIES SET FORTH ARE EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES, REMEDIES AND CONDITIONS.

TP-Link warrants the TP-Link branded hardware product contained in the original packaging against defects in materials and workmanship when used normally in according with TP-Link’ s guidelines for some period which depends on the local service from the date of original retail purchase by the end-user purchaser.

For technical support, the user guide and other information, please visit https://www.tp-link.com/support/, or simply scan the QR code.