WALKERS R600 Silencer Ear Buds with Bluetooth User Guide
- June 13, 2024
- WALKERS
Table of Contents
WALKERS R600 Silencer Ear Buds with Bluetooth
Included
- Left and Right Silencer Electronic Ear buds
- Small / Medium / Large (Right / Left) Sure-Lock™ sizing fins (6 total)
- Small / Medium / Large (one set for each ear) Foam tips (6 total)
- Four pack of batteries
- Detachable Lanyard
- Cleaning Brush / Magnetic tool
- Carry Case
**Installing batteries : (estimated battery life of 80 hours) ***
Remove the foam tip and rubber fin from the Silencer to access the battery
compartment. Install battery using the magnetic brush / wand.
WARNING
Do not mix new and old batteries.
Note the direction of the positive (+) and negative (-)
Operation
Slide switch up to turn the unit ON – down for OFF
Volume is controlled by the dial – turning clockwise will increase the volume
while counterclockwise will reduce the volume,.
Proper Fitting
After installing the batteries close the battery door. At this point you
should try any combination of sizing fins and foam tips to obtain a good seal
and secure fit. Do so with the unit in the off position.
Sure-Lock™ sizing fins slide over the housing.
Install the foam tips to the foam tip post on the device.
When ready to insert into ear. Roll and compress the foam tip between your
fingers. Insert into your ear and hold in place for 10-15 seconds to allow the
foam to expand and seal within your ear.
Properly sealed Silencer will significantly reduce outside noise – muffling
the ambient sound. – Be sure and have the Silencers in the OFF position when
testing how well the foam tips have been seated in your ears.
LIMITED WARRANTY
Walker’s warrants this product to the original purchaser to be free from defects in materials and workmanship, under normal use and conditions for a period of One Year from the date of the original purchase. Under this warranty, this unit will be replaced or repaired at our option, without charge for parts or labor, excluding batteries, for this period
This warranty is void if any of the following occur:
- The warranty card was not sent in at the time or purchase
- The unit is not owned by the original purchaser at the time of the warranty claim
- The unit has been tampered with, opened or punctured
- The unit has been immersed in water or other liquids, allowed to be filled with dirt or dust, or otherwise physically abused
This shall be the exclusive written warranty of the original purchaser and neither this warranty or any other warranty, expressed or implied, shall extend beyond the 12-month period listed above. In no event shall Walker’s be liable for consequential damages, consequential property damage, or consequential personal injury. (Some states do not allow limitations on implied warranties or exclusions of consequential damages, so that these restrictions may not apply to you). This warranty gives you specific legal rights, and you may have other rights, which vary from state to state.
TOLL-FREE CUSTOMER SUPPORT 877-269-8490
FCC NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Shielded interference cable must be used with the equipment in order to comply
with the limits for a digital device pursuant to Subpart B of Part 15 of FCC
Rules.
Specifications and designs are subject to change without any notice or
obligation on the part of the manufacturer.