SHARP KP-Y32P Electric JAR Pot Reboil User Manual

SHARP KP-Y32P Electric JAR Pot Reboil

Please see the date of manufacture marked on the product
Thank you for your trust in products of Thai City Electric Co., Ltd. In order to use electric jar pot in efficiency way. Please read the instructions manual carefully before using this appliance.

SAFETY INSTRUCTION

Please read thewarning and instructionfor use carefully before using this appliance and comply strictly for your own safety and to prevent the damage that may occur on your property.

• The appliance is to be supplied through a residual current device (RCD) having a rated residual operating current not exceeding 30 mA.
• This appliance is considered to be suitable for use in countries having a warm damp equable climate. It may also be used in other countries.
• Tropical climate.

WARNING:

1. Before connect the magnetic plug to body examine if anything stuck with it, remove before plugging.
2. Insert the plug into the wall outlet firmly and when disconnecting, hold the plug and pull it out without touching the power cord.
3. Do not immerse the set in water, it may cause electric leakage or damage of the electric jar pot.
4. Do not put ice cubes or pour milk, mineral water, liquor, tea and tea leaves, herbs or other liquid into the inner pot other than clean water for use. The pipe of the electric jar pot may be clogged.
5. Do not put the electric jar pot on the edge of table as it may fall down and cause damage.
6. Do not put the electric jar pot on a wet floor, under direct sunlight or near the gas stove.
7. Do not cover the steam outlet with a towel etc. Otherwise the hot water may spill over or the share of the lid may change.
8. Do not pour hot water while boiling because splashing hot water may cause burn.
9. Do not touch the steam outlet with your hand may cause burn.
10. Never connect the plug with your wet hand as it maybe dangerous from electric leakage.

INSTRUCTION FOR USE

1. Keep out of reach of infants and children as get scald when the electric jar pot is  tipped over and hot water spills out,  or when the child suck at the spout.
2. In case the power cord is broken, it must be replaced with specialized power cord or the standard power cord made by manufacturer or appointed service providers.
3. Avoid using disassemble or repair the electric jar pot by yourself. It may cause trouble such as a fire or electric shock. Consult your nearest dealer.
4. This appliance is intended to be used in household and similar applications such as
   • Staff kitchen areas in shops, offices and other working environments;
   • Farm houses;
   • By clients in hotels, motels and other residential type environments;
   • Bed and breakfast type environments.
5. Move the electric jar pot by handle only and unplug the power card.
6. Avoid using till water above the “Full” level, the water may spill out from the spout when boiled.
7. Avoid using boil water below the “refill” level, it may lead to damage. Add some more water to full level.
8. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
9. Children should be supervised to ensure that they do not play with the appliance.
10. Close lid firmly, otherwise hot water outflow so much when tumbling.
11. Often examine the power supply cord, the defective power supplycord or plug may cause burning fire or electric shock.
12. Avoid using the electric jar pot for defrosting frozen food.\

DESCRIPTION OF PARTS

Safety pipe

Note:

• The safety pipe is not already attached in the electric jar pot. So, before using the electric jar pot, you should take the safety pipe (packed in plastic bag) and put it into the pipe hole at the bottom of the electric jar pot (please see the above picture).
• Sometimes the safety pipe may fall off the pipe hole if the electric jar pot falls over or is hit by something.In this case.The safety pipe should be put back i’nto the pipe hole before use (please see the above picture).

SPECIFIC INFORMATION

218 X 415 X 290
Weight (kg)| 2.6| 2 . 8
IP number| IPXO

• Detail is subject to change without prior notice.

HOW TO USE

Be sure that the rated voltage is 220V only before use. For the first use, boil water and pour out by pressing the pump button many times to let hot water out through spout. Then pour out the remaining water, carefully clean inner pot and lid.

Fill the inner pot with water

1. Pushing the latch knob to open the lid.
2. Pour water within the range of “Full” level and do not splash water to the body.
3. Push down the lid until a “click” sound is heard.

Bolling water and keeping warm

1. Connect the magnetic plug to body. (Be sure that it is firmly connector)

2. Insert the other end of the plug into the wall outlet.

3. When the plug is inserted into the wall outlet, the “BOIL” indicator lamp lights up, then the electric jar pot starts boiling.

4. When boiling is over the “BOIL” indicator lamp goes off and change to “WARM”. The electric jar pot automatically change over to keep water hot as long as power is connected. The average temperature of hot water is 100 C. then gradually goes down to 85 C – 93 C.
   Note

   • Color of inner pot may be changed depending on water quality. Use clean water.
   • Sounds are emitted during the boiling and warming. But this is quite normal.

5. If the hot water 100°C is required, press the “Reboil 100 ° C” button to reboil.
   Note: Do not press “Reboil 100 C” button to boil water below “Refill” level.

Pour hot water

1. Set the safety knob at “POUR” position.
2. Press the pump button to pour hot water.
3. Do not press the pump button the water will not flow out.
   Note: The safety knob prevents in case of unintentional use.

AFTER USING

1. Disconnect the plug from the wall outlet.
2. Rinse the inner pot with water, if the water is left in the inner pot.it may collect water deposit and cause corrosion.

REMOVING THE LID

1. Push the latch knob found in the front part of the lid, then open the lid.
2. Shift the lid forward, and lift it up, then it can be detached.

CLEANING AND MAINTENANCE

When not using the pot for a long period

Rinse the inner pot with water, drain off by placing the body upside down wipe off moisture in the inner pot well. If the water is left in the inner pot, it may collect water deposit and cause corrosion.

How to cleaning

Before cleaning, be sure to disconnect the plug, pour out the remaining water and cool down the body. Do not use polishing powder, hard brush, thinner, alcohol or other solvent, otherwise the surface may be damaged or discolored.

• Body, lid and handle soak a soft cloth in water. squeeze properly and wipe carefully.
• Inner pot should be cleaned every week by soaking a sponge with water. Then rub the inside of the inner pot carefully. Rinse and drain sufficiently with water.
  Note : Do not use sharp thing or hard bush to rub inside of the inner pot as the poly-flan coated surface may be damage.

When the inner pot was discolored due to different water quality

1. Mix vinegar with (1 :”1 ), pour the mixer water up to the “Full” level of the inner pot and let it boils.
2. After boiling, let it stand for one hour, then pour out the vinegar.
3. Soak a sponge with water and rub the inside of the inner pot carefully. The rinse thoroughly with water until vinegar smell goes out.
4. After cleaning, fill water up to MFull” level and let it boils, then pour out the water as usual before regular use.

EARTH WIRE ASSEMBLY

1. Remove magnetic plug before assembly earth wire.
2. Remove the lid assembly. (See “REMOVING THE LID”)
3. Upside down the electric jar pot.
4. Disconnect rotating base.
5. Remove the nut for earth wire about 2-3 mm. (Symbol @ ) and insert earth wire ass’y and fasten nut for earth wire. (Fig. 1)
6. Assembly rotating base and assembly earth wire to ground. (Fig. 2)

EXCHANGE PACKING

1. Loosen 3 screws holding the inner lid
2. Pull the inner lid packing off from the inner lid.
3. Renew the inner lid packing of the proper side that fits the inner lid.
4. Assembled in the same manner that you removed.

Note : Inner lid packing has a life-time of use. When it is over, pouring water out may be impossible. Inner lid packing exchange is a service.

THE SPECIAL FEATURE

• ELECTRIC PUMP for easy to pour water.
• Re-boiling to 100°C is possible by pushing
• 0 “Reboil 100 C” button.
• The inner pot coat by poly-flon for easy-to-clean. The poly-flon coat is heat proof and harmless to health.
• Model KP-Y40P max water volume 4.0 _f, for to use in restaurant, hotel or office.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>