HEPACART HCAR3618 AnteRoom Expander Installation Guide

June 13, 2024
HEPACART

HEPACART -HCAR3618 -AnteRoom -Expander -LOGO

HEPACART HCAR3618 AnteRoom Expander

HEPACART -HCAR3618 -AnteRoom -Expander -PRODUCT IMAGE

Product Information

Product Name: Expander Module
Version: 2023.1
Contact Phone: 913-789-9590
Email: info@hepacart.com
Website: www.hepacart.com

Product Usage Instructions

  1. Step 1: Installation
    Follow the installation instructions below to install the Expander Module:

    • Refer to Figure 1 for a visual representation of the Expander Module.
    • Contact our support team at 913-789-9590 or via email at info@hepacart.com if you need any assistance during the installation process.
  2. Step 2: Completion of Installation

Once the installation of the Expander Module is complete, follow the steps below to begin using it:

  1. * Relocate the AnteRoom to your desired location.
    • Refer to Figure 3 for a visual representation of the AnteRoom.
    • Contact our support team at 913-789-9590 or via email at info@hepacart.com if you have any questions or require further assistance.

Expanders increase the overall depth of the HEPACART prefabricated AnteRoom. Expanders are available for both HCAR36 and HCAR48 product lines in depths of 12″ and 24″. Expanders can be stacked to any depth desired.

PREPARATION
Place AnteRoom and expander in close proximity and remove plastic plugs from AnteRoom and the pre-installed fasteners on the expander module.

HEPACART -HCAR3618 -AnteRoom -Expander -FIG \(1\)

ATTACH EXPANDER

Supplies Required: (12) 1/4-20 Truss Head Screws, (12) 1/4-20 Thumb Nuts With couplers facing the AnteRoom tilt expander module back and connect expander floor frame to AnteRoom floor frame. Ensure that the slot on the bottom of the expander hooks onto the angle bracket on the AnteRoom.

HEPACART -HCAR3618 -AnteRoom -Expander -FIG \(2\)
Replace (12) 1/4-20 screws and thumb nuts removed in Step 1 this time using them to attach to the AnteRoom.

RELOCATE CASTERS

Supplies Required: #3 Phillips bit and driver
Remove the right most casters from the top and bottom of the right hand side of the AnteRoom and relocate them to the right most holes on the expander. Use screws removed from the expander module to fill in holes left by removing casters from the AnteRoom.

HEPACART -HCAR3618 -AnteRoom -Expander -FIG \(3\)

Installation of the expander module is now complete. Relocate AnteRoom to desired location and begin use.
913-789-9590
info@hepacart.com
www.hepacart.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals