Yoobao EN1200Q Portable Power Station User Guide
- June 13, 2024
- Yoobao
Table of Contents
Yoobao EN1200Q Portable Power Station
Thanks for purchasing
- To ensure a better operating experience for your mobile phone or electronic product,
- Please refer to the manual of your mobile phone or electronic product while reading this manual. The first charge is vital to the battery performance of the EN700Q.
- Please connect the Please fully recharge EN7000 for the first recharging.
- Please read the manual carefully before using the product
- Please keep the manual properly for future reference
- Please fully understand the contents of the manual to use the product correctly.
Cautions
To protect you and others from harm and the product from damage, please
read the manual carefully before using the product
About storage
Do not expose the product to an extreme cold or hot environment (below -0°C or above 40°C) for storage;
- Do not place the product near the vent of a heating device;
- Please avoid putting the product in a rainy or wet environment;
- Please keep it away from flammable liquids, gases or explosive materials;
- Please keep it away from dust or a dusty environment:
- Do not store the product with coins, jewelry, keys and other metal objects;
Otherwise, it will damage the product, reduce the charging capacity, shorten the service life, or even explode. The product should be stored in a cool and dry environment.
About Charger
- Do not use a defective charger or a charger of mismatched output voltage;
- Please use the original charger, as incompatible or unqualified chargers may cause danger or damage the product.
About storage of leaving unused
- Please make sure to charge it at least once every 6 months to extend the life of the product (battery cells). When taking out the product after long-term storage, please fully charge it before use. When the product charger is not in use, the power must be disconnected at both ends. 4.About disposal of defective\old battery and charger
- Please dispose of scrapped products in accordance with regulations, and do not dispose the built-in batteries as domestic garbage to avoid explosion and pollution. 5.Do not squeeze or pierce the product, and do not subject the product to high external pressure, otherwise it may cause internal short-circuit, overheating, burning or explosion. 6.Do not place this product in the reach of people with low physiology, perception, and mentality (including children) and people without experience and related knowledge. Avoid the above people from using this product to avoid misuse.
- The product cannot be used as a substitute for the mains AC power supply in order to extend the cycle life of the battery cells
- Do not paint or put up stickers on this product. Paint and stickers may block the equipment parts and affect normal use.
- About the environment temperature for charging.
- Do not store the product in hot or cold places, please use the product in an environment of 0~60°C;
- The temperature inside a closed car in summer can be as high as 80°C (putting the product in a car may put you or your car in danger.)
- Do not directly expose the product to sunlight for a long time, since when the heat dissipation is not started, the temperature of the battery cells will rise sharply. When charging the product, the operating temperature should be between 0°C~40°C.
- Do not store the product near or inside water heaters, microwave ovens, hot cooking products, or high and low pressure parts, which may may cause overheating or cause fire.
About product cleaning
- Use a dry towel or eraser to wipe the product or charger
- Do not use corrosive chemicals or cleaner.
- Please do not disassemble, repair or modify the product, otherwise warranty will be invalid.
Operation
Cautions
- Due to low power status during transportation, the residual power showy on digital screen may be different from actual power. It will get normal al charging and discharging for 2-3 times.
- When using this product, please do not cover it with towels, clothing, etc and make sure to keep more than 10cm of heat dissipation space around the product.
- Please keep the product and electrical products dry to prevent moisture and liquid from entering the product, otherwise it may damage the internal parts or circuits of the device.
- Do not use the product in a very dusty environment, otherwise it may cause product failure, fire or explosion.
- Do not use the product in flammable and explosive environments such as gasoline, gas, chemical agents, mines, etc., otherwise it may endanger safety Always operate in accordance with regulations, instructions and signs in potentially explosive environments
- Do not use the product in a corrosive environment, otherwise it will cause damage to the product.
- Do not use the product during thunderstorms. The product may malfunction and increase the risk of lightning strikes.
- Please place the product on a flat surface to prevent the product from falling, otherwise it may damage the product or cause parts failure.
About recharging the product
- Please use Yoba original charger to charge the product.
- Do not exceed the charging time of this product. Please unplug the charger when fully charged. It is recommended to charge during the day or when someone is present for easy inspection
- Due to energy conversion during charging, this product may heat up. This is a normal phenomenon. Please be careful when handling.
About the discharge of the product
- When the power is 1 bar left or the indicator is flashing, to prolong the life of the battery, please immediately stop using and fully recharge EN700Q before using it again.
Package Contents
The contents will be different according to the needs of different regions.
Please contact with Yoba service center .
Product Introduction
EN1200Q Is a multi-functional emergency energy storage power supply, It adopts UL authorized automobile power cell and efficient SPWM inverter conversion technology. II is more durable and has longer cycle Ille than ordinal’/ battery c,11. It enjoys the reputation of “outdoor mobile power station”. II is widely used in outdoor party and camping. household emergency, outdoor live broadcasting, mobile office, medical rescue, emergency rescue, power equipment repair, communication emergency and other fields. It is compatible with mast of digital appliances and household appliance of power rate under 700W.
Structure and Functions
How to charge the product
Please read the following notes first: Accessories are only equipped. When
using solar panel to charge, it is advised to use 100W or 400W to achieve
higher charging efficiency. with this product. It is forbidden to use on other
electrical product is fully charged when the power indicator stop flashing
and stay on. Please stop charging and unplug the power cord from the AC
socket. We can charge the product in the following three ways: . AC charging
The product adopts quick charging technology for AC charging, and the maximum
input power can reach 1000W.
Charging with solar panel
Connect one end of the cable to the solar panel (solar panel needs to be
purchased separately), and insert the other end into the DC input “DC5521 IN”
interface of the product to charge the product (It is recommended to buy solar
panels specially designed for this product).
3. Charge with a cable with car charger plug connect the car charger plug to the cigarette lighter and the other end to DC input “DC5521 IN” interface of the power station.
How to use the AC output Please read following cautions before use
- Please ensure that the input voltage and frequency of electrical equipment are consistent with the parameters of this product
- Please ensure that the rated power of electrical equipment is less than 1200W, preferably within 80% power range.
- If the rated power of electrical equipment is higher than 1200W, the overload protection may be activated.
- If the power of electrical equipment is higher than the rated power of 1200W, please choose Yoobao portable power supply with higher power. . The AC output will be off automatically when there is no load more than 12 hours.
- The instantaneous power of some electrical equipment is greater than its rated power. For example, the starting power of inductive load equipment is generally 3-8 times of a certain rated power, and the starting power of energy-saving lamp is dozens of times of its rated power. The above situation does not rule out the possibility of activating the overload protection of this product and turning off the power supply. Steps of using the AC output
Step 1 Turn it on with the AC button and the indictor will be on. Remaining power can be seen on LED screen.
Step Check whether the input voltage and frequency is compatible with the product.
Step 3 Make sure the rated power of appliances is under 700W.
Step 4 Connect the appliance to the AC output.
The parameter is incorrect .Image size is not supported. Each image dimension must be between 40 and 2600 pixels.
How to use
he DC output When using DC output(include USB-A output, DC output, Type-C PD 100W output), please ensure that the digital device support the current of the corresponding output port, so as to prevent the interface from overheating and causing damage to the device. 1. Use USB ports to charge digital devices 2 ways to use USB output:
- USB-A QC3.0: the orange
- USB-A can provide QC3.0 quick charge, it will need a cable supporting QC3.0 protocol to connect power station and the digital devices. Long press the DC button and the power station will charge the digital devices quickly.
USB-C: USB-C output interface, also known as Type-C, can provide PD fast charging and the output power is 100W. It will need a cable supporting PD protocol to connect power station and the digital devices. Long press the DC button and the power station will charge the digital devices quickly
Use DC output to power appliances Long press DC button, the DC indicator light will be on and two DC ports start to provide power at voltage 12V and total current 6A. Connect to the DC output to power appliances. Long press the DC button again, the DC indicator will be off and the power will be cut. This DC output can provide power to DC fan and LED lights etc. When you are not using DC output, please turn it off with the DC button, otherwise the remaining power will be consumed by itself.
Steps to use flashlight
The product has a built-in flashlight. 1. Strong LED reading light, short- press the switch to turn it on and switch the modes of luminance: strong-›soft-›SOS
Please don’t use the flashlight directly point to eyes to avoid the damage from strong light.
After-sales services
-
To ensure your legal right, please pay attention to:
- The warranty card must be sealed by the seller before it can take effect.
- The warranty card shall be properly kept by the user. If it is lost or altered, it will be invalid.
- In case of any failure caused by non-human reasons, you can take the warranty card to the designated repair center for free repair within the warranty period.
- Free maintenance service will be unavailable under the following circumstances even within the warranty period:
- You will no longer enjoy the warranty if you disassemble, refit or repair the product without permission;
- Damage of surface coating and appearance is not within the scope of warranty;
- Failure caused by incorrect installation, packaging and use which is not in accordance with the requirements of the user manual;
- Failure or damage caused by accidental, man-made reasons or environment and other factors (wrong operation, collision, unreasonable voltage, damp, etc.);
- Failure or damage caused by force majeure like earthquake, fire disaster, tsunami Product packaging box and accessories are not within the scope of warranty
- If your product has expired the warranty period, we offer compensated repair service.
Name and content of toxic and hazardous substances or elements in the
product
Warranty card
Please store the warranty card well and fulfill your information and send back together with the product
Dear customer
Thank you for your trust and support to our products. The warranty card is attached with each product. Please keep it properly as a product warranty certificate. If it is lost, it will not be replaced. Thank you.
Dongguan YOOBAO Communication Devices Co. LTD Address: Building Town, Dongguan, Guangdong, China Website: www.yoobao.com Email: sales@yoobao.cn