Infinix X6835 Hot 30 Play Smartphone User Manual
- June 13, 2024
- Infinix
Table of Contents
Infinix X6835 Hot 30 Play Smartphone
Explosion diagram specification
| 1 | FL(CTP+LCM) | 2 | F HSG ASM |
|---|---|---|---|
| 3 | PS RUBBER | 4 | PCBA COPPER C |
| 5 | PCBA COPPER A | 6 | PCBA COPPER B |
| 7 | PCBA MB | 8 | PCBA GRAPHITE FILM |
| 9 | F CAM FRAME | 10 | F CAM |
| 11 | FPC SIDE KEY | 12 | F CAM COPPER |
| 13 | REC | 14 | REC COPPER |
| 15 | FM | 16 | CARD HOLDER |
| 17 | R CAM CON FOAM 16M | 18 | R CAM 16M |
| 19 | R CAM CON FABRIC 8W | 20 | R CAM 8W |
| 21 | LCM CONN RUBBER | 22 | BAT CONN RUBBER |
| 23 | MAIN WATERPROOF FRAME | 24 | MAIN WATERPROOF MYLAR |
| 25 | MI HOUSING | 26 | MI RAD GRA |
| 27 | 28 | SCREW L3.5 | |
| 29 | R FLASH DECO | 30 | R CAM DECO 16M |
| 31 | R CAM RUBBER 8W | 32 | BAT COVER ASM |
| 33 | R FLASH LENS | 34 | R CAM LENS 16M |
| 35 | R CAM LENS 8W | 36 | R CAM DECO 8W |
| 37 | SCREW L2.0 | 38 | SUB CONN RUBBER |
| 39 | SPK | 40 | MOTOR LINEA |
| 41 | PCBA SUB | 42 | USB RUBBER |
| 43 | EARPHONE RUBBER | 44 | BAT |
| --- | --- | --- | --- |
| 45 | COAXIAL CABLE |
Know your phone
- Front camera
- Volume + key
- Volume – key
- Power key & side fingerprint sensor
SIM/SD card installation
- Power off mobile.
- Refer to the following picture for SIM / SD card installation.
Charging the phone
- You can charge your device using a charger or by connecting it to the computer using a USB cable (comes with the phone).
- Use only INFINIX charger and cables. Other chargers or cables may damage the device. This will invalidate your phone warranty.
FCC Caution
Labelling requirements.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Information to user.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR) information:
This mobile phone meets the government’s requirements for exposure to radio
waves. The guidelines are based on standards that were developed by
independent scientific organizations through periodic and thorough evaluation
of scientific studies. The standards include a substantial safety margin
designed to assure the safety of all persons regardless of age or health. FCC
RF Exposure Information and Statement The SAR limit of USA (FCC) is 1.6 W/kg
averaged over one gram of tissue. Device types: X6835(FCC ID:2AIZN-X6835) has
also been tested against this SAR limit. The highest SAR value reported under
this standard during product certification for use at the ear is 1.11W/kg and
when properly worn on the body is 1.24W/kg.
Body-worn Operation
This device was tested for typical body-worn operations. To comply with RF
exposure requirements, a minimum separation distance of 1.0 cm must be
maintained between the user’s body and the handset, including the antenna.
Third-party belt-clips, holsters, and similar accessories used by this device
should not contain any metallic components. Body-worn accessories that do not
meet these requirements may not comply with RF exposure requirements and
should be avoided. Use only the supplied or an approved antenna. For DTS
patents, see http://patents.dts.com. Manufactured under license from DTS
Licensing Limited. DTS, the Symbol, & DTS and the Symbol together are
registered trademarks or trademarks of DTS, Inc. in the United States and/or
other countries. © DTS, Inc. All Rights Reserved.
Operating System： AndroidTM Android is a trademark of Google LLC.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>