Chieftec CMR-625 5.25-Inch Removable Frame User Guide
- June 13, 2024
- CHIEFTEC
Table of Contents
CMR-625
5,25” Backplane for 6x 2,5” HDD/SSD
User Guide
www.chieftec.eu
details
Package contens
Backplane…………………………………………………………………………1PCS
HDD/SSD trays………………………………………………………………….6PCS
SATA cable………………………………………………………………………..6PCS
Rack screws………………………………………………………………………4PCS
HDD/SSD tray screws……………………………………………………….24PCS
User guide…………………………………………………………………………1PCS
Security lock keys……………………………………………………………….2PCS
Security lock keys……………………………………………………………….2PCS
Intended use
This device is intended for installation in a 5.25” slot of a computer
chassis. It allows quick changing of 2.5” SATA SSDs/HDDs without opening the
computer chassis.
This device complies with the applicable national and European requirements.
All names of companies and products are trademarks of the respective owners.
All rights reserved.
Safety instructions / Remarks
The warranty will be void in the event of damage caused by failure to observe
these safety instructions. We don’t accept liability for damage to property or
personal injury caused by incorrect handling or non-compliance with safety
instructions.
In such cases the warranty will be null and void.
Because of safety reasons it’s not allowed to modify or change any device
features.The device is not a toy and should be kept out of the reach of
children. features.The device is not a toy and should be kept out of the reach
of children. No part of the device may get damp or wet. Keep the packing
material out of the reach of children. Handle the product with care, it can be
damaged by impacts, blows, or accidental falls, even from a low height.
All product specifications are subject to change based on the actual product
description. We reserve the right to change or modify any product
specifications without notice!
We will not be liable for any software, hardware or data stored within or
interfacing with CHIEFTEC products which results in damage or malfunction. To
utilize the hot swap function, the host must also support this function. Even
if the SATA controller supports hot swap function, we recommend that you don’t
remove the hard drive during operation, because the backward motion during
removal could cause the write/read head to make contact with magnetic disk in
the drive, which destroys the hard drive.
Installation
Install the device in a free 5.25″ drive bay and use the rack screws which are
included in delivery to fix the device properly in the pc chassis.
Connect the 4PIN molex power connector(s) from your psu to the device and also
the SATA data cables which are also included in scope of delivery to your
mainboard or controller card.
slide the release mechanism of the device tray to the left and release the
tray to install a HDD/SSD with four screws from below as shown on the image as
follows:
Now slide the tray back in the cage and repeat the installation process for
all HDDs/SSDs you want to install. This device accommodates drives with up to
9.5mm height.
Operation
If you don’t have the expertise to install the device correctly, please
contact an expert, specialist workshop or your local dealer and let them carry
out the installation!
If you insert a brand new hard drive into the backplane make sure that its
partitioned and formatted before the system detects it properly. In Windows
systems you can format it easily in the control panel under disk management.
Switch off the computer in which the device is to be installed and ensure that
all connected devices are separated from the main voltage. Therefore pull the
mains plug off! Note’ turning off at only the on/off switch is not enough!
Each hard drive tray can be released if the key lock is open. All necessary
keys are included in delivery.
Disposal
Electrical and electronic devices do not constitute household waste. Dispose of unserviceble products in accordance with the relevant statutory regulations.
© Copyright
This user guide is a publication of Arena Electronic GmbH, Koppersstr. 18,
D-40549 Dusseldorf.
All rights including translation reserved. Reproduction by any method, e.g.
photocopy microfilming or the capture in electronic data processing systems
require the prior written approval by the editor. Reprinting, also in parts,
is prohibited.
These user guide represent the technical status at the time of printing.
Changes in technology and equipment reserved.
© Copyright 2016 by Arena Electronic GmbH
Manufacturer
Arena Electronic GmbH
Koppersstr. 18
40549 Dusseldorf, Germany
Model No.: CMR-625
www.chieftec.eu
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>