ILP EXS1-U-2RW EXS Series Thermoplastic LED Exit Sign Instruction Manual
- June 13, 2024
- ILP
Table of Contents
INSTALLATION INSTRUCTIONS
Emergency Exit Sign
Instruction Manual
MODEL NUMBERS
EXS1-U-2RW, EXS1-U-2GW
EXS1-U-2RW-B, EXS1-U-2GW-B
EXS1-U-2RW-B-RC, EXS1-U-2GW-B-RC
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
- Do not use outdoors.
- Do not mount near gas or electric heaters.
- Equipment should be mounted in locations and at heights(MAX:8ft) where it will not be subject to tampering by unauthorized personnel.
- The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
- Do not use this equipment for other than its intended use.
- Before wiring to power supply, turn off electricity at fuse or circuit breaker.
- Consult local building code for approved wiring and installation.
- Installation and servicing should be performed by qualified personnel.
SAVE THESE INSTRU CTIONS
INSTALLATION INSTRUCTIONS
IMPORTANT:
When relamping, only use lamps specified in the exit sign.
Using other lamp types may result in transformer damage or unsafe conditions.
CEILING & END MOUNTING (FIG.1) & (FIG.2).
- Connect input as shown in wiring diagram below and fasten canopy to J-box bracket.
- Snap housing to canopy.
- Secure faceplate to housing and remove the proper arrow as required.
Wiring diagram for -RC Models
- EXS1-U-2RW-B-RC
- EXS1-U-2GW-B-RC
Wiring diagram for -AC Models
- EXS1-U-2RW
- EXS1-U-2GW
Wiring diagram for -B Models
- EXS1-U-2RW-B
- EXS1-U-2GW-B
WARNING:
Unused wires must be capped using enclosed wire nuts.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>