ILP RB4-14L-U-CCT RB4 Round High Bay Instruction Manual
- June 12, 2024
- ILP
Table of Contents
ILP RB4-14L-U-CCT RB4 Round High Bay Instruction Manual
Introduction
Tools Needed:
- Flat Head Screwdriver
Warning:
To avoid the risk of fire, explosion, or electric shock, this product shall be
installed, inspected, and maintained by a qualified electrician, in accordance
with all applicable electrical codes.
Warning:
To avoid electric shock
- Allow product to cool before servicing.
- Be certain electrical power is OFF before and during installation or maintenance.
- Luminaire must be connected to a wiring system with equipment-grounding conductor.
Installation
Step 1
Use a flat head screwdriver to loosen the center panel . (FIG.1)
Step 2
Adjust the switch to the desired setting. (FIG.2) See tables on page 2 for
more information.
Step 3
Reattach the center panel. Ensure that it is secured tightly.
Step 4 (Sensor Installation)
Follow steps 1-2 from above. Plug in the sensor into the center of the unit.
Follow the provided sensor manufacturer instructions for complete setup.
Switch Controls
CCT Selection
Switch 1| CCT
35K| 3500K
40K| 4000K
50K| 5000K
Lumen Selection
Switch 2 (Optional)| RB4 SKU| Lumens
100W| 14L| 14000 lm
150W| 21L| 21000 lm
200W| 28L| 28000 lm
To complete installation, turn power On, check for proper operation of luminaire.
ILP, LLC
519 Codisco Way, Sanford, FL 32771
Phone: (407) 478 3759
Fax: (407) 478 3760
www.ilp-inc.com 