IFIXIT HTC Wizard 200 Screen Cover Replacement Instruction Manual

: June 4, 2024
: IFIXIT

Table of Contents

HTC Wizard 200 Screen Cover Replacement
INTRODUCTION
Step 1 — Battery
Step 2 — Back Panel
Step 7 — Motherboard
Step 12 — Keyboard Slider
Step 13 — Screen Cover
Documents / Resources

HTC Wizard 200 Screen Cover Replacement

Installation of the screen cover on the HTC Wizard 200.
Written By: Kyle Champ

INTRODUCTION

This guide will explain how to install/remove the screen cover from the HTC Wizard 200.

TOOLS:

iFixit Opening Tool (1)
Spudger (1)
T5 Torx Screwdriver (1)

Step 1 — Battery

To expose the battery, remove the outer case with your fingernail.
Remove the battery by pulling the black tab.

Step 2 — Back Panel

Insert the flat end of the spudger into the two notches on the back of the camera cover and pry them up.

Step 3

Work the spudger around the edges of the camera cover until it comes off.

Step 4

Remove the four 6 mm screws with the T5 Torx screwdriver.
One of the screws is under the “void” sticker.

Step 5

Insert the flat end of an iFixit opening tool between the side and inner covers to create a gap.
Work the tool around the edges until all the clips release.

Step 6

Once all the clips are open, remove the inner panel from the phone.

Step 7 — Motherboard

Use the spudger to pry the camera off.

Step 8

Using tweezers, flip the connector latch away from the motherboard.
Detach the flexible connection from under the connector latch.

Step 9

Slide the keyboard into the open position.

Step 10

Lift the motherboard out of the case using the spudger.
Expose the underside of the motherboard using your hands.

Step 11

Remove the flexible connection from the motherboard.
Caution: Removing the connection too fast may cause damage to the connection and cables.

Step 12 — Keyboard Slider

Remove the four 5mm screws with the T5 Torx screwdriver.
Remove the keyboard slider from the main body.

Step 13 — Screen Cover

Use the T5 Torx screwdriver to remove four 5mm screws that secure the back of the screen casing.

Step 14

Insert the plastic opening tool between the front panel and the rear panel and pry it open to reach the screen.

Step 15

Once the rear panel is loose, lift it off of the front panel.
The flexible connection will pop loose.

Step 16

Device rotated 90 degrees CCW.

Remove the yellow anti-static tape.

Step 17

Unscrew the two 3mm phillips #0 screws from the bottom of the device that secure the rigid-flex board to the screen panel.

Step 18

Device rotated 180 degrees CW.

Unscrew the two 3mm phillips #0 screws from the top of the device that secures the rigid-flex board to the screen panel.

Step 19

Device rotated 90 degrees CCW.

Unhinge the flexible connection and use the tweezers to disconnect.

Step 20

Now that the rigid-flex board is loose, remove it from the screen.

To reassemble your device, follow these instructions in reverse order.
This document was generated on 2022-06-02 01:08:01 PM (MST).

HTC Wizard 200 Screen Cover Replacem…
Guide ID: 6836 -Draft: 2022-05-26
© iFixit — CC BY-NC-SA
www.iFixit.com

Documents / Resources

| IFIXIT HTC Wizard 200 Screen Cover Replacement [pdf] Instruction Manual
HTC Wizard 200 Screen Cover Replacement, Wizard 200 Screen Cover Replacement, Screen Cover Replacement, Replacement
---|---