IFIXIT HTC Wizard 200 LCD Screen Replacement Instruction Manual

HTC Wizard 200 LCD Screen Replacement
Instruction Manual
Written By: Kyle Champ

INTRODUCTION

This guide will explain how to install/remove the LCD screen from the HTC Wizard 200.
TOOLS:

• Phillips #0 Screwdriver (1)
• Spudger (1)
• T5 Torx Screwdriver (1)
• Tweezers (1)
• iFixit Opening Tool (1)

Step 1 — Battery

• To expose the battery, remove the outer case with your fingernail.
• Remove the battery by pulling the black tab.

Step 2 — Back Panel

• Insert the flat end of the spudger into the two notches on the back of the camera cover and pry them up.

Step 3

• Work the spudger around the edges of the camera cover until it comes off.

Step 4

• Remove the four 6 mm screws with the T5 Torx screwdriver.
  One of the screws is under the “void” sticker.

Step 5

• Insert the flat end of an iFixit opening tool between the side and inner covers to create a gap.
• Work the tool around the edges until all the clips are released.

Step 6

• Once all the clips are open, remove the inner panel from the phone.

Step 7 — Motherboard

• Use the spudger to pry the camera off.

Step 8

• Using tweezers, flip the connector latch away from the motherboard.
• Detach the flexible connection from under the connector latch.

Step 9

• Slide the keyboard into the open position.

Step 10

• Lift the motherboard out of the case using the spudger.
• Expose the underside of the motherboard using your hands.

Step 11

• Remove the flexible connection from the motherboard.
  Caution: Removing the connection too fast may cause damage to the connection and cables.

Step 12 — Keyboard Slider

• Remove the four 5mm screws with the T5 Torx screwdriver.
• Remove the keyboard slider from the main body.

Step 13 — Screen Cover

• Use the T5 Torx screwdriver to remove four 5mm screws that secure the back of the screen casing.

Step 14

• Insert the plastic opening tool between the front panel and the rear panel and pry it open to reach the screen.

Step 15

• Once the rear panel is loose, lift it off of the front panel.
• The flexible connection will pop loose.

Step 16

The device rotated 90 degrees CCW.
Remove the yellow anti-static tape.

Step 17

• Unscrew the two 3mm Phillips #0 screws from the bottom of the device that secure the rigid-flex board to the screen panel.

Step 18

The device rotated 180 degrees CW.
Unscrew the two 3mm Phillips #0 screws from the top of the device that secures the rigid-flex board to the screen panel.

Step 19

The device rotated 90 degrees CCW.
Unhinge the flexible connection and use the tweezers to disconnect.

Step 20

• Now that the rigid-flex board is loose, remove it from the screen.

Step 21 — LCD Screen

• Simply pull out the loose screen.

To reassemble your device, follow these instructions in reverse order.

This document was generated on 2022-05-30 at 11:27:19 AM (MST).
© iFixit — CC BY-NC-SA
www.iFixit.com

References

• iFixit: The Free Repair Manual
• Spudger: The Essential ESD-Safe Pry Tool - iFixit
• T5 Torx Screwdriver: Precision Star-Shaped Bit Driver
• Tweezers: ESD-Safe, Pointed/Angled/Blunt Tips

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>