UltraLux LPW24CCT LED Ceiling Lamps Installation Guide
- June 12, 2024
- ULTRALUX
Table of Contents
UltraLux LPW24CCT LED Ceiling Lamps
**This product contains a light source of energy efficiency class D.
**
TECHNICAL PARAMETERS
Voltage AC: ……………………. 220-240 V AC/ 50-60 Hz
Power:…………………………. ..2 4 W
Rated luminous flux:………….. ………. 2400 Im
Correlated Cal or Temperature (CCT): ……………………….. 3000/4000/6500 K {adjustable)
Beam Angle·: .. ……………………………………………….. 12,QP
Color Rendering Index {(RI): ………………….. Ra>BO
Working temperature: ………………. -10°( + +40 °c
Protection rating: ……………………………….. IP54
Dimensions: …………………………………. 220/55 mm
Warranty: …………………………………………. 2 years\
SAFETY INSTRUCTIONS
- Performing any activity with the power supply on constitutes potentja1I hazard of electric shock. Prior to mounting, power supply must be switched off by using the mains switch.
- The fixture can be installed only on a flame-resistant base wi1th ignition temperature, at the least 200 °C and does not deform or soften (e.g. metal, concrete, plaster).
- Activities related to connection to the power supply are to be commissioned to a person with appropriate authorization.
- The fixture, when properly assembled, may only be connected to a properly functioning electrical system with compliance with the applicable standards.
- Clean only with dry doth
- The light fixture heat itself while working, so in case of necessity prior to undertaking its replacement, wait until cool down.
- Do not cover the fixture. To avoid any fire hazard, provide unrestricted air flow to the heated fitting parts.
- Prior to starting operating, make sure the mounting of the product has been performed appropriately, eliminating the hazard of defective operation, not endangeri1ng the surrounding ,and the users.
- The importer/supplier bears no responsibility for damages resulting from fail ure comply with these instructions.
INSTALLATION
-
Turn off the power supply·
-
Hold both sides of the handle to remove the bracket, unscrew the screw to remove the back cover.
-
Pass the cable through the center hole of the bracket and screw the bracket to the ceiling.
-
The cable passes through the guard sleeve and is connected to the term1inaL Choose a ,color temperature.
-
Secure the ,cable and install the back cover according1to the original position.
-
Put the wire into the groove of the chassis.
-
Point the light at the bracket and buckle it.
-
Installed ceiling light.
-
Turn on the power supply.
TAKINIG CARE OF THE NATURAL ENVIRONMENIT CLEANLINESS
- The product and its components are not harmful to the environment.
- Please dispose, the package elements separately in containers for the corresponding material.
- Please dispose the broken product separately in containers for out of usage electrical equipment.