legrand RH-253-W Single Pole Momentary Switch User Manual
- June 12, 2024
- Legrand
Table of Contents
legrand RH-253-W Single Pole Momentary Switch
PRODUCT DESCRIPTION
Wattstopper’s Residential Multi-way Sensors (RH-250, RD-250, CH-250, CD-240,
and CU-250) can be wired with up to four RH-253 single pole momentary wall
switches for multi-way Manual-ON/OFF Automatic-OFF control of one load. The
Multi-way sensor must be installed in the wiring wall box that connects to the
load. See the Multi-way sensor instructions for more information. Install
according to all codes and standards.
CAUTION: Use this device with copper or copper-clad wire only. Terminal
screws can accommodate up to 12 AWG wire. Loop each wire around terminal
screw. Loop ground wire around the green terminal screw.
WARNING
DISCONNECT POWER TO THE WALL SWITCH BOX BY TURNING OFF THE CIRCUIT BREAKER OR
REMOVING THE FUSE FOR THE CIRCUIT BEFORE INSTALLING THE RH-253, REPLACING
LAMPS, OR DOING ANY ELECTRICAL WORK.
WIRING AND INSTALLATION
Wiring one Multi-way sensor and one RH-253 single pole momentary switch for multi-way Manual-ON/OFF single load control.
- Connect the green or non-insulated (copper) GROUND wire in each wiring box to the green terminal on each Multi-way sensor and RH-253.
- Connect the NEUTRAL wire from the circuit and from the lamp (LOAD) to the white wire on the Multi-way sensor.
- Connect the power wire from the circuit box (HOT) to one terminal of the RH-253 and to the TRAVELER 1 wire.
- Connect the TRAVELER 1 wire coming from the RH-253 wiring box to the black wire of the Multi-way sensor.
- Connect the lamp power (LOAD) to the red wire on the Multi-way sensor.
- Connect the TRAVELER 2 wire to the other side of the RH-253 and to the yellow wire of the Multi-way sensor.
- Mount switch in wall box using mounting screws provided.
- Install industry standard decorator wall switch cover plate (not included).
- Restore power to the circuit.
To wire up to four RH-253 single pole momentary wall switches to one Multi- way sensor, wire them in parallel as shown in the following wiring diagram.
COVER PLATES
Wattstopper RH wall switches fit behind industry standard decorator style switch cover plates.
WARRANTY INFORMATION
Wattstopper warranties its products to be free of defects in materials and workmanship for a period of five (5) years. There are no obligations or liabilities on the part of Wattstopper for consequential damages arising out of, or in connection with, the use or performance of this product or other indirect damages with respect to loss of property, revenue or profit, or cost of removal, installation or reinstallation.
Customer Support
800.879.8585
www.legrand.us/wattstopper
Documents / Resources
|
legrand RH-253-W Single Pole Momentary
Switch
[pdf] User Manual
RH-253-W Single Pole Momentary Switch, RH-253-W, Single Pole Momentary Switch,
Momentary Switch, Switch
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>