MUZEN Audio MW-JS1 Wild Jeep Outdoor Personalized Portable FM Radio Bluetooth Speaker Instruction Manual

MUZEN Audio MW-JS1 Wild Jeep Outdoor Personalized Portable FM Radio

Bluetooth Speaker

Product Information

• Dimensions: 100mm x 80mm
• Weight: 157g
• Compliance: Complies with IMDA Standards
• Model Number: DA106614
• Manufacturer: Shenzhen Airsmart Technology Co., Ltd.
• Manufacturer Address: Unit 616, Ant’s Union Start-up Accelerator, No.9 Keji Road, Science and Technology Park, Nanshan District, Shenzhen, China
• Contact Information:
  • Email: info@muzenaudio.com
  • Website: www.muzenaudio.com

Product Usage Instructions

1. Ensure the device is fully charged before use.
2. To turn on the MUZEN Radiooo, press and hold the power button located on the device.
3. To switch between FM radio and Bluetooth speaker modes, use the mode selection button.
4. To tune to different FM radio stations, use the tuning knob or the seek buttons.
5. For Bluetooth pairing, enable Bluetooth on your desired device and search for “MUZEN Radiooo” in the available devices list. Once found, select it to establish a connection.
6. Adjust the volume using the volume control buttons.
7. To pause or resume audio playback, press the play/pause button.
8. To skip to the next track, press the next track button.
9. To go back to the previous track, press the previous track button.
10. For any further assistance or troubleshooting, refer to the user manual or contact MUZEN Audio’s customer support.

Welcome to the MUZEN Family! Thanks for choosing us to accompany you on your life adventure. Please read this manual carefully and make sure to follow the relevant safety instructions before using it. MUZEN Audio is excited to launch the well-designed portable bluetooth speaker series, Radiooo. The MU ZEN Radiooo Bluetooth speaker adheres to the company’s design philosophy of “Aesthetically pleasing, Great sound, User-friendly and Entertaining”. It is our eternal pursuit to make you enjoy the music and sound contents easier and better. Welcome to explore your Radiooo.
Reminder: This product is battery-powered. For better experience of the product, please charge it for about two hours with it powered off before first-time use.

Packing List

Speaker Dperating Instructions

(Notes: Left picture is the assembled Radiooo Jeep Speaker, and when you take off the Jeep outer case, you get the standardized inner speaker as right picture shows)

1. Power Switch /Mode Knob
   The power switch and mode function are both set on the same knob. Turn to the corresponding position such as Bluetooth/FM/AUX to achieve the corresponding function and turn to the “OFF” position to shut down.

2. FM turning knob
   With FM mode, you could search your favorite radio station by turning the knob.

3. Indicator light
   To display the connection status of the device in different modes.

4. Bluetooth Mode
   Flashing white light: Ready for Bluetooth pairing Steady white light: Bluetooth connected

5. AUX Mode
   In AUX mode, the product can be connected to an external signal source (mobile phone, PC, etc.} through the standard AUX audio cable. Please turn the mode knob to AUX mode when in use, play the music while the indicator light is orange.

6. FM Mode
   You can find your favorite radio station by rotating the FM tuning knob. The indicator light will turn green when the radio station well received, and the indicator light won’t turn green if it receives weak signal.
   Note: The engraved FM frequency on this product may have some deviation for the actual radio frequency, which is normal. The frequency scale is for reference only, and the actual receiving frequency shall prevail.

7. Volume Knob

   • Volume up: Rotate clockwise
   • Volume down: Rotate counterclockwise

8. Multi-function USB port (charging,AUX INPUT}
   This port can be used for charging and audio connection in AUX mode. For charging, to insert the charging cable (or other compatible charging cable) into the USB port on the back of the device, and use a SV-lAor more than IA charger to charge.

9. Charging Light

   • While Charing: red light
   • Fully charged: green light. It takes about3 hours to fully charge the battery

10. Headphone/FM antenna interface
    This port can support3.5mm audio output device or FM antenna access.

11. Anti-counterfeiting nameplate
    Radiooo series exclusive anti-counterfeiting nameplate, with exquisite craftsmanship, wear-resistant beautiful design, antioxidant properties.The surface details are clearly identifiable under the magnifying glass, and the shape is regular.

Product Feature

1. Radiooo series is equipped with standardized inner speaker, which can be replaced and assembled with different cases at will.
2. Adopt first-class radio chip, optional antenna, excellent receiving sensitivity.
3. A special electro-acoustic design is adopted, adjusted by a professional tuner, and it has very good sound quality.

Hardware Parameters

• Product model: MW-JSI
• Bluetooth version: 4.0
• Receiving sensitivity: 3UV
• Frequencyrange: 87-lOSMHz
• Power: Bluetooth /AUX INPUT SW  FM4.5W
• Amplifierpower: SW
• Amplifier impedance: 40
• Signal-to-noise ratio: > 70dB
• System frequency response: 80Hz-20KHz
• Battery: 800mAh/7.4V
• Charging port: Micro USB
• Chargingvoltage: DCSV=lA
• Product size: 144mm87mm66mm
• Net weight of speaker: about 834g

Important Notes

For your safety, please read the following instructions carefully and comply with them:

1. The manufacturer reserves the right to modify or adjust the specifications and details of the product without notifying users.
2. Please use the product in a dry environment wherever possible.
3. The product should not be placed near or in contact with exposed sources of fire.
4. The product is non-waterproof design, please pay attention to water when using it. If you do not use it for a longtime, please keep it in a ventilated, cool and dry place.
5. Please do not charge the product at the same time while the speaker is on.
6. Do not modify, repair or dismantle this product without authorization.
7. Note that if the battery is not replaced properly, it may explode. Only the same or equivalent type of battery can be used for replacement. The product will no longer enjoy warranty seivice after the battery has replaced.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction Federal Communication Commission (FCC) Radiation Exposure Statement Power is so low that no RF exposure calculation is needed. This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications or changes to this equipment. Such modifications or changes could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radiofrequencyenergy and, is not installed and used in accordance with instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

This device complies with Part 15 of the RCC Rules and with RSS-247 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This Class B digital apparatus complies with Canadian ICES-003.

SIMPLIFIED EU DECLARATION OF CONFORMITY
Hereby, Shenzhen Airsmart Technology Co., Ltd. declares that the radio equipment type MW-JSl is in compliance with DIRECTIVE 2014/53/EU. The declaration of conformity may be consulted at our website, accessible form: www.muzenaudio.com
This product can be used across EU member states

Maintenance Regulations

• Limited warranty: one year. For warranty details, please visit www.muzenaudio.com or contact our local distributors.
  Email: www.muzenaudio.com

• Manufacturer: Shenzhen AirsmartTechnologyCo., Ltd.

• Address: Unit 616,Ant’s Union Start-up Accelerator,No.9 Keji Road,Science and Technology Park, Nanshan District,Shenzhen,China

Q&A Frequently Asked Questions

• Q: How to charge? How longdoesittaketocharge?
  A: Use the sv~ ( 1A-2A) charger or use the USB for charging. When the Status indicator light turns red, it means charging, and when it shows green, it means the battery has fully charged. At this time, please tum off the charger or unplug the charging cable. It takes approximately 3 hours to be fully charged under normal circumstances.

• Q: How long does the battery last?
  A: In Bluetooth mode, the playtime is around 6 hours; in radio mode, the playtime is around 10 hours. When the speaker tuned to the maximum volume, the Bluetooth mode lasts!: 3 hours, and the radio mode lasts!: 5 hours.

• Q: How to replace the battery?
  A: The built-in B00mAH Li-polymer battery can be replaced. Remove the four screws that fix the battery, and then the battery can be removed for replacement

• Q: Can I use the speaker while it is charging?
  A: It is recommended not to use the speaker while it’s charging. The sound quality may be affected in Bluetooth mode; It may interfere with the reception performance of the radio while it’s charging.

• Q: Does the radio have to use FM antenna?
  A: Not necessary. If you want a clearer and better radio performance, then can configure FM antennas.

• Q: How do the indicator lights work?
  A: Please look at the indicators’ instruction table:

• Q: Can’t connect the Bluetooth?
  A: If you encounter problems when connecting this device to a Bluetooth device, you may try the following steps:

1. To clear the Bluetooth pairing records has stored in the device;
2. Restart the Bluetooth function of the device, find the Bluetooth name of “Radiooo-seriesl” and reconnect.  

• The engraved FM frequency on this product may have some deviation for the actual radio frequency, which is normal. The frequency scale is for reference only, and the actual receiving frequency shall prevail.

info@muzenaudio.com
www.muzenaudio.com

References

• Retro Portable Radio Mini Bluetooth Speaker | Muzen Audio

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>