sudio S2 Portable Speaker Owner’s Manual

sudio S2 Portable Speaker Owner’s Manual

Included in the box

1. S2
2. Charging cable
3. Warnings folder
4. Owners Manual

Pairing to a device

1. Hold (►) 3 seconds to turn S2 on
2. Hold ( ) 2 seconds to connect to device, LED will blink amber 2x.
3. Hold ( ) 2 sec to disconnect, S2 will go into pairing mode, LED will blink white 2x

Playback operations

Play and pause 1x click(►)
Volume up 1x click (+)
Volume down Ix click (-)
Next track hold 2 sec (+)
Previous track hold 2 sec(-)

Phone call operations

Accept calls: 1x click on the (► ) button
Hang up or reject calls: Hold the (► ) button 2 seconds

Battery indication

The LED lights red when battery is under 10%

Broadcast function

1. Turn on both S2 speakers by holding (► ) 3 sec
2. Click ( ) 1x on the first S2
3. Click ( ) 1x on the other S2 to link
4. Connect to device
5. End broadcast by pressing ( ) button 1x

Charging

Use USB-C to charge.
Red light charging.
No light charged.

Factory reset

Hold (►) 5 seconds to reset, the LED will blink white x3.

FCC Statement[for Remote control
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class 8 digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential instalation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help.

This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter. Radiation Exposure Statement

The device has been evaluated to meet general RF exposure requirement in portable exposure condition without restriction.

Sudio Help Center

www.sudio.com/helpcenter

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>