DURR DR44 One Piece Toilet Instruction Manual
- June 12, 2024
- DURR
Table of Contents
DURR DR44 One Piece Toilet Instruction Manual
To ensure this product is installed properly, please read these instructions carefully before you begin. (Certain installations may require professional help.)Also be sure your installation conforms to local codes.
CAUTION: HANOLE WITH CARE. VITREOUS CHINAWARE FRAGILE WITH SHARP EDGES IF
BROEKN.
NOTE: Pictures may not exactly define contour of china and components.
RECOMMENDED TOOLS AND MATERIALS
Putty knife
Hacksaw
Flathead Screwdriver
Flexible Supply Hose
Adjustable Wrench
Water Supply Kit
Sealant Tape Measure
Carpenters Level
1 REMOVE OLD TOILET
- a. Turn off water supply valve and flush tank completely. Towel or sponge remaining water from tank and bowl.
- b. Disconnect and remove old water supply line. Note: If replacing valve, first shut off main water supply!
- c. Remove old mounting hardware, remove toilet and plug floor flange to block sewer gases from escaping.
- d . Remove closet bolts from flange and clean away old wax, putty, ect. from base area.
NOTE: MOUNTING SURFACE MUST BE CLEAN ANO LEVEL BEFORE NEW TOILET IS INSTALLED.
2 ROUGHING-IN DIMENSIONS:
NOTE: Distance from wall to closet flange centreline must be as listed on chart:
3 INSTALL CLOSET BOLTS
Insert Floor bolts into flange channel with bolt head down (use plastic retaining washers to hold the bolts in Fu length. Floor bolts should be parallel to wall and s•(152mm) apart.
4 INSTALL WAX RING
Turn toilet bowl down onto a towel or cushioned surface Place the wax reground the draining outlet of the bowl and press firmly enough. Apply a thin bead or sealant around toilet base.
5 POSITION TOILET BOWL ON FLANGE
a. Unplug Floor waste opening. gently place the bowl In pos1tIon with the
floor bolts protruding up through the hole in the base
b. Press down with sight I motion on the top center of bowl to compress the
wax ring creating a water-tight seal
c. Place plastic disc, metal washers and nuts on floor bolts.
6 INSTALL TOILET
a. Using a hacksaw. cut off excess length of floor bolts so bolt caps will
fit(leave no more than 1/4″Iength above nuts.)
Alternately tighten nuts until toilet bowl is firmly seated on floor.
DO NOT OVERTIGHTEN NUTS BECAUSE VITREOUS CHINA CAN EASILY CRACK OR CHIP.
b. Pour water into bowl to prevent the escape of sewer gases.
c. Place bole caps over floor bolts and press down for secure fit.
d. Smooth off the bead of sealant around base. Remove excess sealant.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>