SBi AC01263 Projection kit Instructions
- June 12, 2024
- SBI
Table of Contents
Projection kit installation
2″/ 4″
2″/ 4″ (AC01263)
Cuttable Faceplate Installation
34″ x 50″ (AC01277)
AC01263 Projection kit
Prior to the installation of the insert, measure the distance from the insert faceplate to the front of the fireplace opening. If the distance is greater than 0″, a projection kit must be installed before the installation of the insert faceplate.
Application
This projection kit and cuttable faceplate are to be installed on an insert. The projection kit is used when the insert needs to protrude from the fireplace opening. It allows a 2″ or 4″ protrusion. The cuttable faceplate can be installed if the fireplace opening is bigger than the insert cast iron faceplate. Both cuttable faceplate and projection kit can be installed separately.
Kits Content
AC01277
|
---|---
34″ X 50″ cuttable faceplate
(1x)| Self-adhesive gasket
(9 pi)
AC01263
Installation of a 2″ projection
- Fold each section on the micro joints to separate them into two 2″ section. Discard the top part (grey) and keep the bottom part of each section.
- Install the mounting brackets (D) on the projection sections with the screws (C) provided.
- Assemble the projection side panels (G) and (I) to the top panel (F) with 2 bolts (E) and 2 nuts (H).
- Install the projection kit using the bolts (E) located on the back of the faceplate (J).
- Align the holes on the cuttable faceplace (K) with the corresponding holes in the mounting brackets and secure with 9 screws (C).
- Align the faceplate hooks with the insert and slide the faceplate down to hook it on the insert.
Installation of a 4″ projection
- Assemble the projection side panels (G) and (I) to the top panel (F) with 2 bolts (E) and 2 nuts (H).
- Install the projection kit using the bolts (E) located on the back of the faceplate (J).
- Align the holes on the cuttable faceplace (K) with the corresponding holes on the projection panels and secure with 9 screws (C).
- Align the faceplate hooks with the insert and slide the faceplate down to hook it on the insert.
Installation of the cuttable faceplate
- It is possible to install only the cuttable faceplate on the insert. Cut the faceplate to the appropriate size and fix it on the insert faceplate with the screws (C) provided.
- Cut the gasket in three sections of the appropriate lenght. Install the self-adhesive gasket on the back edge of the cast iron faceplate. The excess gasket should be inside the facade.
- Align the faceplate hooks with the insert and slide the faceplate down to hook it on the insert.
This document is available for free download on the manufacturer’s website. It is a copyrighted document. Resale is strictly prohibited. The manufacturer may update this document from time to time and cannot be responsible for problems, injuries, or damages arising out of the use of information contained in any document obtained from unauthorized sources.
250, rue de Copenhague,
St-Augustin-de-Desmaures (Québec) Canada
G3A 2H3
1-877-356-6663
tech@sbi-international.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>