SBI AC01223 Heat Shield for Shelf Mantel Instruction Manual

June 12, 2024
SBI

Heat Shield for Shelf / Mantel
Installation Instructions
AC01223SBI AC01223 Heat Shield for Shelf Mantel 46127AF
2023-04-28

Application

This heat shield is used to reduce the minimum height required between the base of a fireplace and a combustible shelf when installing a zero clearance fireplace. This heat shield fits under the shelf and can accommodate a shelf depth from 6″ (152 mm) to 12″ (305 mm) and up to 84″ (2.1 m) in length.

Kit Contents

Shelf Heat Shield (A) 1x Heat Shield Support Bracket (A) 6x Quadrex Black Screw #10-5/8″ (A) 30x

Suggested Hardware (Not included)

Suggested hardware #8 – 3/4″ (min.) (D)

Tools Required

| Pliers
---|---
| Cutting pliers
| Drill with drill bit 3/16″
| Measuring Tape
SBI AC01223 Heat Shield for Shelf Mantel - Featured
Image| Screwdriver

Installation Instructions

A) Make sure the shelf height required by the fireplace manufacturer is respected.SBI AC01223 Heat Shield for Shelf Mantel - Featured
Image B)  Measure the shelf to determine the length and width needed of the heat shield.SBI AC01223 Heat Shield for
Shelf Mantel - Featured Image

C)  Make a back-andforth motion to break the heat shield at the desired location to obtain the necessary width. Available widths are 6″, 8″, 10″ and 12″. The heat shield must cover the entire shelf. Break also the support to the right width.SBI AC01223 Heat Shield for Shelf Mantel - Featured
Image D)  The heat shield must cover the entire shelf.SBI AC01223 Heat Shield for Shelf Mantel - Featured
Image

Note : Assuming that the shelf is centered with the fireplace, there should be no support 8″ on each side from the center of the shelf (hatched area).
E) Position a support on each side of the hatched area. Then position a bracket at each end of the shield, centered on the width and 1″ from the end. The maximum distance between each support should be 16″. If the distance is greater, add a support at an equal distance between the two. Mark the location of the holes using the notches in the support. Using a drill, pre-drill the holes in the screen.SBI AC01223 Heat Shield for Shelf Mantel - Featured
ImageF) Paint the necessary quantity of supports and the heat shield with high temperature paint.SBI AC01223 Heat
Shield for Shelf Mantel - Featured ImageG) Position the brackets on the shelf. Do not use holes drilled in the heat shield as a model. The holes are not located at the same place! Position a support on each side of the hatched area. Then position a support at each end of the screen 1″ from the end and 1
½” from the edge. Use the same number of supports as for step D). For a 6″ shelf use two screws, for a shelf of more than 6″, use 3 screws.SBI AC01223
Heat Shield for Shelf Mantel - Featured ImageH) Install the heat shield on the brackets with the screws included in the kit. For a 6″ shelf use two screws. For a shelf of more than 6″, use 3 screws.SBI AC01223 Heat Shield for Shelf Mantel - Featured
Image

SBI ACCESSOIRES DE CHAUFFAGE
250 rue De Copenhague
Saint-Augustin-de-Desmaures
Québec, Canada
G3A 2H3
1-877-356-6663

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals