Danfoss 014G2479 Ally Boiler Relay User Guide
- June 12, 2024
- Danfoss
Table of Contents
ENGINEERING TOMORROW
Ally™ Boiler Relay
014G2479
Mains 230V~ RF, V/F output
Quick Guide
014G2479 Ally Boiler Relay
COMFORT UP COSTS DOWN
IT’S THAT SIMPLE
ALLY™
BY DANFOSS
Please, be aware that the installation should be done only by trained
professionals and the placement must be according to local building
regulations.
Please use the manual provided with your gateway, and follow the instruction
to download the App.
http://scn.by/krzp87a5z2ak6f
Youtube Video Guide
Remove the front and mount Danfoss Ally™ Boiler Relay back plate direct to
wall or on a wall box.
Connect the “N” and “L”
terminals to the mains power and wire as required for application.
NOTE: Please, refer to the boiler instructions, in order to identify the
correct terminals in the boiler. 
| Type | Terminal Marking | Description |
|---|---|---|
| N | N | Mains power 230VAC (neutral) |
| L | L | Mains power 230VAC (phase) |
| 1 | No connection | Leave blank |
| 2 | COM | Common of relay change over switch |
| 3 | ON | COM connects to this pin when heat is on, NO |
| 4 | OFF | COM connects to this pin when no heat is requested, NC |
| E | Extra terminal | Can be used for fixating unused wire. No connection |
Continue system setup in the Ally™ App.
Safety precautions
SIMPLIFIED EU DECLARATION OF CONFORMITY Hereby, Danfoss A/S declares that the
radio equipment type Danfoss Ally™ Boiler Relay is in compliance with
Directive 2014/53/EU. The full text of the EU declaration of conformity is
available at the following internet address:
www.danfoss.com.
The Danfoss Ally™ Boiler Relay is not intended for children and must not be
used as a toy. Do not leave packaging materials where children may be tempted
to play with them, as this is extremely dangerous. Do not attempt to dismantle
the Danfoss Ally™ Boiler Relay as it contains no user-serviceable parts.
| Transmission Frequency: 2,405 – 2,480 GHz | Transmission Power: < 10 dBm |
|---|---|
| Danfoss Ally™ Boiler Relay must be disposed of as e-waste |
Technical Specifications
| Power supply | Input: Mains 230V~ 50/60 Hz |
|---|---|
| Output | Volt free 3(1)A at 250V~ |
| Operating temperature range | 0 °C to 40 °C |
| Terminals | Max 2.5 mm² wires |
| Control pollution situation | Degree 2 |
| Controller type | 1B |
| Software class | A |
| Over voltage category | III |
| Temperature for Ball pressure test | 75 °C |
| Danfoss Ltd., |
22 Wycombe End,
HP9 1NB, GB|
---|---|---
Homepage: www.danfoss.com
Danfoss cannot accept any responsibility for possible errors in catalogues,
brochures, videos and other material. Danfoss reserves the right to alter its
products without notice. This also applies to products ordered but not
delivered provided that such alterations can be made without changes to form,
fit or function of the product.
All trademarks in this material are property of Danfoss A/S or Danfoss group
companies. Danfoss and the Danfoss logo are trademarks of Danfoss A/S. All
rights reserved.
AN45455446162501-000101
© Danfoss
014R0007
08/2023
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>