sanexo Series Daisy Shower Tray Instruction Manual
- June 4, 2024
- sanexo
Table of Contents
sanexo Series Daisy Shower Tray
INSTALLATION
- Before installing the tray, must install the feet and waste firstly, the waste should be connected with the hard tube or hose, and then connect the hard tube or hose with the sewage system
- Flowing direction test:
- Remove the waste cover, and then use the towel or dishcloth to plug the waste hole.
- Pour the water to fill the tray by the shower or scoop.
- Remove the towel, and observe the drainage.
- If you observe the water is staying, please refer to photo 3 to adjust the height of the feet. (If there is no water staying ,then can go on next installing step)
- Increase the height of the feet which is near the stagnant water, and then test the flowing repeatedly to reach the minimum water logging statu.
Montagearten
-
The installation of tray
The installation of the tray being matched with plinth A.Install the floor before installing the tray. (Convex Type)
Run some silicone on the position where the plinth rests on the tray after fitting the plinth. -
Sinking Type
Install the tray before installing the floor.
Make sure the tray and flat floor are on the same level. -
Platform type
Can install ceramic tile on the position where there is no plinth.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>