euromate 482235 Tower Fan Instruction Manual

482235
482280

tower fan

Overview

Assembly

Operation

Before you begin…

Intended use

The product is intended exclusively for non-commercial operation as a mobile fan.
This product is not intended for commercial use. Generally acknowledged accident prevention regulations and enclosed safety instructions must be observed.
Only perform work described in these instructions for use. Any other use is improper. The manufacturer will not assume responsibility for damage resulting from such use.

What are the meanings of the symbols used?

Danger notices and information are clearly marked throughout these instructions for use. The following symbols are used:

DANGER! Direct danger to life and risk of injury! Directly dangerous situation that may lead to death or severe injuries.

WARNING! Probable danger to life and risk of injury! Generally dangerous situation that may lead to death or severe injuries.

CAUTION! Possible risk of injury! Dangerous situation that may lead to injuries.

NOTICE! Risk of damage to the device! Situation that may lead to property damage.
Note: Information to help you reach a better understanding of the processes involved.

For your safety

General safety instructions

• To operate this device safely, the user must have read and understood these instructions for use before using the device for the first time.
• Observe all safety instructions! Failure to do so may cause harm to you and others.
• Retain all instructions for use, and safety instructions for future reference.
• If you sell or pass the device on, you must also hand over these operating instructions.
• The device must only be used when it functions properly. If the product or part of the product is defective, it must be taken out of operation and disposed of correctly.
• Never use the device in a room where there is a danger of explosion or in the vicinity of flammable liquids or gases.
• Always ensure that a device which has been switched off cannot be restarted unintentionally.
• Do not use devices with an on/off switch that does not function correctly.
• Keep children away from the device! Keep the device out of the way of children and other unauthorised persons.
• Do not overload the device. Do not use the device for purposes for which it is not intended.
• Exercise caution and only work when in good condition: If you are tired, ill, if you have ingested alcohol, medication or illegal drugs, do not use the device, as you are not in a condition to use it safely.
• This product is not intended to be used by persons (including children) or who are limited in their physical, sensory or mental capacities or who lack experience and/or knowledge of the product unless they are supervised, or have been instructed on how to use the product, by a person responsible for their safety.
• Ensure that children are not able to play with the device.
• Always comply with all applicable domestic and international safety, health, and working regulations.

Electrical safety

• The device may only be connected to a socket that is correctly installed and grounded.
• The fuse must be a residual current circuit breaker with a measured residual current of no more than 30 mA.
• Make sure that the power supply corresponds with the connection specifications of the device before it is connected.
• The tool may only be used within the specified limitations for voltage and power (see type plate).
• Do not touch the mains plug with wet hands! Always pull out the mains plug at the plug and not by the cable.
• Do not bend, crush, pull or drive over the power cable, protect from sharp edges, oil and heat.
• Do not lift the device using the cable or use the cable for purposes other than intended.
• Check the plug and cable before each use.
• If the power cable is damaged immediately disconnect the plug. Never use the device if the power cable is damaged.
• If the device is not in use make sure the plug is pulled out.
• Make sure that the device is switched off before plugging in the mains cable.
• Make sure that the device is switched off before unplugging it.
• Disconnect the power supply before transporting the device.

Device-specific safety instructions

• The product must be standing on an even, horizontal surface with clearance to all sides.
• The product may not be operated outdoors.
• Never put objects through the protective grille into the product.
• Objects that can be pulled (e. g. curtains, plants), must not be in the immediate vicinity.
• Never expose the product to water or other liquids.
• The product must not be operated in rooms with bathtubs, showers or swimming pools or near to wash basins or water connections.
• Remember that moving parts may also be located behind ventilation and venting slots.
• Symbols appearing on your device may not be removed or covered. Signs on the device that are no longer legible must be replaced immediately.

****Read and observe the instructions for use before using the product for the first time.

DANGER! Risk of death through electric shock! The use of this variant outside Switzerland is not permissible for safety reasons, as this poses a risk of electric shock or fire.

The variant of the product sold in Switzerland may only be used in Switzerland, as it is equipped with a Swiss plug.
You can identify the variant by means of the item number on the product (the instructions always contain all item numbers):

• Item number Switzerland: 482280
• Item number in other EU countries: 482235

Your appliance at a glance

Note: The actual appearance of your product may differ from the illustrations.

Overview

1. Switching knob
2. Timer knob
3. Control panel
4. Fan body
5. Front base
6. Rear base
7. Power cord

Scope of delivery

• tower fan
• base (consisting of 2 parts)
• set of operating instructions
• screw

Unpacking

-­ Remove all parts from the packaging.
-­ Check all parts are present and no defect before assembly.

Setting up

Assembly
– Pass the power cord (7) through the central gate and firmly clamp the front base (5) with the rear base (6), then adjust the position of fan body with that position of the base, and fix the screws of the base with a screwdriver
-­ Pass the power cord through the gap of the base.

Operation

Operation
-­ Insert the mains plug into a mains socket corresponding to the technical data.

120 minutes timer
P. 3, item 3
• [ON]: timer on
• [OFF]: timer off
• [30-60-90-120]: minutes
P. 3, item 4
• [OFF]: to turn off the fan
• Speed selection: turn on the fan by selecting the speed: [1] -­ Low, [2] ­- Med., [3] ­- High
• Oscillation [ ]: The speed with [ ] means there is oscillation.

Cleaning

DANGER! Caution, risk of injury! Alway disconnect to the supply main before maintenance.

­- Turn off the product, pull out the mains plug.
­- Clean the fan with a soft damp cloth. Do not immersed the fan in water.

Storage and transport

Storing
-­ Store the device and any accessories in a dry, well-ventilated place.
-­ In case of longer periods without operation, protect the device and its accessories against soiling and corrosion.

Transport
-­ Use the original packaging to ship whenever possible.

Troubleshooting

If something stops working…
DANGER! Risk of injury! Improper repairs can result in the product functioning unsafely. This endangers yourself and your environment.

Malfunctions are often caused by minor faults. You can easily remedy most of these yourself. Please consult the following table before contacting the vendor. You will save yourself a lot of trouble and possibly money too.

If you can’t fix the fault yourself, contact your nearest vendor. Please be aware that any improper repairs will also invalidate the warranty and additional costs may be incurred.

Disposal

Disposal of the appliance
A crossed-out wheelie bin icon means: Batteries and rechargeable batteries, electrical or electronic devices must not be disposed of with household waste. They may contain substances that are harmful to the environment and human health.
Consumers must dispose of waste electrical devices, spent portable batteries and rechargeable batteries separately from household waste at an official collection point to ensure that these items are processed correctly. Information on returning these items is available from the seller. Sellers are required to accept these items free of charge.

Technical data

Batteries, rechargeable batteries and lamps that are not permanently installed in waste electrical equipment and can be removed in a non-destructive way must be removed and disposed of separately before disposal of the equipment. Lithium batteries and rechargeable battery packs of all systems are only to be handed in to the waste collection points in a discharged state. The batteries must always be protected against short circuits by taping off the poles.
All end users are responsible for deleting any personal data stored on waste devices prior to their disposal.

Disposal of the packaging
The packaging consists of cardboard and correspondingly marked plastics that can be recycled.
– ­Make these materials available for recycling.

Information requirements

1 42929 Wermelskirchen GERMANY

Claims for defects

Dear customer, Our products are manufactured in modern production plants, and are subject to an internationally recognised quality process.
Nevertheless, if you have cause for dissatisfaction, please bring the item together with the proof of purchase to the store from which you bought it.
For our products, legal claims for defects are valid from the date of purchase.

Euromate GmbH
Emil-Lux-Straße 1
42929 Wermelskirchen
GERMANY
Hotline +49 (0) 2196 / 76-3333
www.euromate.de

Art.-Nr. 482235, 482280

V-181121

References

• euromate

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>