SSUINSS IT14 H23 Smartwatch User Guide
- June 12, 2024
- SSUINSS
Table of Contents
SSUINSS IT14 H23 Smartwatch
User Guide
Power on
It takes 2 hours to fully charge the smart watch.
App download and pairing
-
App download
Download and install the “Dafit”app on the App Store,
Google Play or by scanning the OR code below.
http://plus.crrepa.com/app-download/dafit -
Pairing
Please wait for 5-10 seconds, the system will automatically pop up a reminder, click “PAIR”, and the calling Bluetooth will be connected. -
Please wait for 5-10 seconds, the system will automatically pop up a reminder, click “ALLOW”, and the notifications will be shown.
Switch on the notifications on Dafit as belows:
Click the “Phone” icon and the watch could make a dial and answer callings and
play music from the phone. 
How to set the notifications?
Android Notification Setting:
- 0pen Setting in phone
- Click “Notifications & Status Bar”
- Click “App notification management”
- Choose any App to set all allow all notifications as following:
iOS Notification Setting:
- Open Setting in phone
- Click “Notifications”
- Choose the APP to open “Allow Notifications”as following:
FAQs
Why does the Smart Watch automatically disconnect Bluetooth when the Android screen goes out?
1> Lock background APP.When the Da Fit process is cleared, the Smart Watch will be disconnected from the mobile phone. 2 > Set APP self-startup 3 > Unrestricted background operation.The Android mobile phone installed with APP intelligently restricts the background operation by default, and App should be set manually without any restriction.
Why cannot the Smart Watch receive message push?
Why can't take a hot bath with the Smart Watch?
Answer: the bath water has a relatively high temperature, and generates a lot of vapor which is in the gas phase with small molecular radius and can easily infiltrate into the Smart Watch from the shell gap. When the temperature drops down,the vapor will condensate into liquid-phase droplets which will easily cause the short circuit inside the Smart Watch and damage the circuit board and then damage the Smart Watch.
Warning:
Please consult your doctor before you take a new sport. The Smart Watch should
not be used for any medical purpose though it may dynamically monitor the
heart rate at real time.
FCC STATEMENT:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radiofTV technician for help.
The device has been evaluated to meet general RF exposure requirement.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>