SOUNDTUBE SM890i Outdoor Surface Mount Speaker Instruction Manual

June 12, 2024
SOUNDTUBE

SOUNDTUBE SM890i Outdoor Surface Mount Speaker

SOUNDTUBE SM890i Outdoor Surface Mount Speaker

Box contents

  • 1 Speaker
  • 1 Terminal weather boot
  • 1 Mounting bracket
  • 1 Safety cable
  • 1 Euroblock connector
  • 1 5 mm Allen hex key
  • 1 Paint mask

Product Overview

Product Overview

Tap Settings


| 100v| 70v|

25v

6

| Direct| Direct| Direct
5| X| 150|

19

4

| 150| 75| 10
3| 75| 38|

5

2

| 38| 19| 2.5
1| 19| 10|

1.3

The SM890i has a rotatable horn for 85° or 110° coverage. Speaker ships in the 110º vertical (85º horizontal) position. To change to 85º vertical (110º horizontal), follow these directions:

  1. To remove the grille, rotate the grille retention knob counter-clockwise while gently pushing down on the grille. Remove the grille from the speaker by pulling gently on the grille retention knob.
    Installation Instructions

  2. To release the horn, insert hand into horn throat and twist horn assembly counter-clockwise.
    Installation Instructions

  3. To replace horn assembly, insert horn 1/8 turn from final position and rotate clockwise to tighten. Horn is fully engaged when horn baffle throat is aligned with speaker.
    Installation Instructions

  4. Attach grille by pressing down gently and rotating the retention knob clockwise to vertical postion. Grille retention knob will snap into the matching recess in the grille when fully engaged.
    Installation Instructions

Warning
SoundTube speakers must be installed by a professional audio installer/contractor For safety and for optimum audio performance, installer must follow all directions issued by SoundTube Entertainment

Warning
Do not spec or install speaker near support beam, ventilation duct or other structure that may interfere with speaker function or d1spers1on.

Installation Instructions

  1. Unpack speaker and mounting hardware.
    Installation Instructions

  2. Choose a secure mounting surface with sufficient strength to reliably hold the speaker. Mounting bracket accommodates screwing, through bolting and strapping installation options.
    Installation Instructions

  3. For proper bracket and plate orientation, pay special attention to the prongs on the bracket arm and ensure that they point toward the direction of the desired speaker position.
    Installation Instructions

  4. Thread safety cable (included) through mounting screw and securely fasten mounting plate to surface (user must supply fasteners).
    Mounting bracket may also be strap-mounted to pole or appropriate anchor point. The max. strap width is 0.5 in/ 12.7 mm.
    Installation Instructions

  5. Slip terminal weather boot over signal wire. For environmental applications, put sealant around nipple and base when installation is complete.
    Installation Instructions

  6. Connect signal wire to four-pin Euroblock plug. Use inside positive and negative inputs for signal wire input. For daisy chaining, use outside positive and negative terminals to connect additional speakers. Tighten unused terminal screws.
    Installation Instructions

  7. Insert four-pin Euroblock connector into jack on rear of speaker. Connectors are keyed for polarity.
    Installation Instructions

  8. Clip snap-link safety cable to eyebolt on back of cabinet.
    Installation Instructions

  9. Select the desired setting on the rear-mounted tap switch.
    Use table on page 1 to choose appropriate tap number based on system voltage, and desired power draw.
    Installation Instructions

  10. a. When mounting the speaker, ensure that the mounting rod in the speaker securely engages with the mounting prongs on the bracket arm.
    Installation Instructions
    10b. When properly inserted, bracket arm prongs will be fully engaged with the mounting rod in the speaker cabinet.
    Installation Instructions

  11. Position speaker at the desired angle and secure with the clamp knob. As a security feature, an included 5 mm Allen hex key is required for loosening the clamp knob and readjusting the speaker position angle.
    Installation Instructions

  12. Done!

Customers Support

1.435.647.9555
800.647.TUBE
www.soundtube.com

Logo

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

SOUNDTUBE User Manuals

Related Manuals