Rohnson R-7530 Safe Touch Kettle Instruction Manual
- June 12, 2024
- Rohnson
Table of Contents
Kettle R-7530 “Safe touch”
Instructions Manual
IMPORTANT SAFETY INSTRUCTIONS
- Read all instructions before using.
- Before connecting the kettle to the power supply, check that the voltage indicated on the appliance (underside of the kettle & base) corresponds with the voltage in your home. If this is not the case, contact your dealer and stop using the kettle.
- Do not let the cord hang over the edge of a table or counter or touch a hot surface.
- Do not place on or near a hot gas or electric burner or in a heated oven.
- Do not operate the appliance without anything in it to avoid damaging the heat elements.
- Ensure that the kettle is used on a firm and flat surface out of reach of children, this will prevent the kettle from overturning and avoid damage or injury.
- To protect against fire, electric shock, or personal injury, do not immerse the cord, electric plug, or kettle in water or other liquids.
- While water is boiling, or just after the water has been boiled, avoid contact with steam from the spout.
- Always take care to pour boiling water slowly and carefully without tipping the kettle too fast.
- Be careful of refilling when the kettle is hot.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience, and knowledge, unless they have been given supervision or instruction concerning the use of the appliances by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
- Do not touch the hot surface. Use the handle or the button.
- The attached base cannot be used for other than the intended use.
- Extreme caution must be used when moving an appliance containing hot water.
- The appliance is not a toy. Do not let the children with play with it.
- The kettle is for household use only. Do not use outdoors.
- The use of accessories, which are not recommended by the appliance manufacturer, may result in fire, electric shock, or personal injury.
- Unplug the kettle from the outlet when not in use and before cleaning. Allow the kettle to cool before putting on or taking off parts, and before cleaning the appliance.
- To disconnect, turn any control to “off,” then remove the plug from the wall outlet.
- If the supply cord is damaged, it must be replaced by the manufacturer or its service agent, or a similarly qualified person in order to avoid hazards.
- Do not use the appliance for other than the intended use.
- The kettle can only use with the stand provided.
- If the kettle is overfilled, boiling water may spill out.
- Always ensure the lid is closed and do not lift it while the water is boiling. Scalding may occur if the lid is removed during the brewing cycles.
- Save these instructions.
SAVE THESE INSTRUCTIONS
HOUSEHOLD USE ONLY
Notes on the cord plug:
This appliance has a polarized plug. To reduce the risk of electric shock,
this plug is intended to fit into a polarized outlet only one way, If the plug
does not fit fully into the outlet, reverse the plug, If it still does not
fit, contact a qualified electrician, Do not attempt to modify the plug in any
way.
Notes on the cord:
a) A short power-supply cord (or detached power-supply cord) is to be provided
to reduce risks resulting from becoming entangled in or tripping over a long
cord.
b) Longer detachable power-supply cords or extension cords are available and
may be used if care is exercised in their use.
c) If a long detachable power-supply cords or extension cord is used,
- The marked electrical rating of the detachable power-supply cord or extension cord should be at least as great as the electrical rating of the appliance.
- If the appliance is of the grounded type, the extension cord should be a grounding-type 3-wire cord.
- The longer cord should be arranged so that it will not drape over the countertop or tabletop where it can be pulled on by children or tripped over.
KNOW YOUR ELECTRIC KETTLE
BEFORE USING YOUR KETTLE
If you are using the kettle for the first time, it is recommended that you
should clean your kettle before use by boiling the Max capacity of water once
and then discarding the water twice. Wipe the surface with a damp cloth.
NOTE: The max capacity of the kettle is 1.5L.
USING YOUR ELECTRIC KETTLE
-
Place the kettle on a flat surface.
-
To fill the kettle, remove it from the power base and open the lid by pressing down lid release button, then fill the kettle with the desired amount of water and close the lid. The water level must be within the Min and the Max level. Too little water will cause the kettle to switch off before the water has boiled.
NOTE: Do not fill the water over the maximum level, as water may spill out of the spout when boiling. Ensure that the lid is firmly in place before plugging in the power outlet. 3. Position the kettle on the power base. -
Connect the plug to a power outlet. Press down the switch and the indicator will light up, and then the kettle starts to boil the water. The kettle will switch off automatically once the water has boiled. If necessary, it will take you 30 seconds to wait before pressing the switch again to re-boil the water. You may shut off the power by lifting the switch up or directly lifting the kettle from the power base at any moment to stop the boiling process.
NOTE: Ensure that switch is free of obstructions and the lid is firmly closed, the kettle will not turn off if the switch if be constrained or if the lid is opening. -
Lift the kettle from the power base and then pour the water.
NOTE: Operate carefully when pouring the water from your kettle as boiling water may result in scald, besides, don’t open the lid while the water in the kettle is hot. -
The kettle will not re-boil until the switch is pressed again. The kettle may be stored on the power base when not in use.
NOTE: Always disconnect the power supply when not in use.
BOIL-DRY PROTECTION
Should you accidentally let the kettle operate without water, the function of boil-dry protection will automatically switch off the power. If this occurs, allow the kettle to cool prior to filling it with cold water before re- boiling.
CLEANING AND MAINTENANCE
Always disconnect the appliance from the power outlet and cool it down completely before cleaning.
-
Never immerse the kettle, power cord, or power base in water, or allow moisture to contact with these parts.
-
Wipe the appearance of the body with a damp cloth or cleaner, never use a poisonous cleaner.
-
Remember to clean the filter at intervals. For easier cleaning, detach the filter by pressing down the tab of the filter inside the kettle and then replace it after cleaning.
CAUTION: Do not use chemical, steel, wooden or abrasive cleaners to clean the outside of the kettle to prevent the gloss loss. -
When not use or storage, the power cord may be wound under the bottom of kettle.
REMOVAL OF MINERAL DEPOSITS
Your kettle should be periodically descaled as the mineral deposits in tap water may form scale on the bottom of kettle so as to cause the operation less efficiency. You can use the commercially available descaler and follow the instructions on the package of descaler. Alternatively, you may follow below instructions using the white vinegar.
- Fill the kettle with 3 cups of white vinegar, then adding water to the amount so as to cover the bottom of kettle completely. Leave the solution in the kettle overnight.
- Then discard the mixture in the kettle, then filling the kettle with clean water to the maximum position, boiling and then discard the water. Repeat several times until the odor of vinegar has been flushed away. Any stains remaining inside the spout can be removed by rubbing with a damp cloth.
TECHNICAL SPECIFICATIONS
Rated voltage range | 220-240 V |
---|---|
Rated frequency | 50-60 Hz |
Rated power | 1850-2200 W |
Capacity | 1,5L |
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT
IN ACCORDANCE WITH EC DIRECTIVE 2002/96/EC.
At the end of its working life, the product must not be disposed of as urban
waste.
It must be taken to a special local authority differentiated waste collection
center or to a dealer providing this service.
Disposing of a household appliance separately avoids possible negative
consequences for the environment and health, deriving form inappropriate
disposal and enables the constituent materials to be recovered to obtain
significant savings in energy and resources. As a reminder of the need to
dispose of household appliances separately, the product is marked with a
crossed-out wheeled dustbin.