Lampara E27 LED Light Bulb Instruction Manual

: June 12, 2024
: lampara

Table of Contents

INSTALLATION INSTRUCTIONS
2-year warranty:
Documents / Resources
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

Lampara E27 LED Light Bulb Instruction Manual

INSTALLATION INSTRUCTIONS

The advice of a qualified person may be required for installation. The product can be used outdoors if the luminaire shows the symbol IP44 or IP54, otherwise the product should only be used indoors. The lighting fitting with wooden elements may be installed only in heated rooms. It is recommended to use a YDY 3 x 1.5 mm2 power cord with a double sheath.

RECOMMENDED LIGHT SOURCE: E27, 15W-20W LED BULB

Installation:

Disconnect the power supply.
Strip 6 mm of the power supply cables and run them through the metal base grommet with a grommet.
Screw the base to the base using four appropriately selected screws. Picture 1.
Connect the power wires to the corresponding marked terminals on the connector – phase wire (L) brown and neutral wire (N) blue. Figure 1. If the cube is equipped with terminals 1 and 2, it is possible to divide the light bulbs power supply into two circuits.
Connect the protective earth conductor (usually green and yellow) to the protective terminal marked with the symbol Picture 1
Place the glass in the rim with the matte side down as shown in figure 2.
Screw the plastic handles to the rim using the nuts provided in the kit so that the glass is fixed. Under one of the nuts, put the eye of the green-yellow grounding wire screwed to the base. Figure 3. CAUTION! The plastic handles should be screwed in the correct direction (see figure 3)
Spin the rim clockwise with a dynamic, rapid movement (fig. 4). The housing should be screwed on with sufficient force so that two characteristic clicks are heard, indicating that the elements are in their place. ATTENTION! The second click means that the elements jump into place and pull the luminaire to the ceiling.

The light source used in this luminaire should be replaced only by the manufacturer or its service agent or a similarly qualified person. Maintenance:

Maintenance works should be performed with the power supply disconnected and after waiting for the LED panel to cool down. After disassembling the cover and disconnecting the power supply, clean it with a soft cloth.

selective collecting of electrical equipment|
---|---
luminaire powered by alternating current| luminaire for ceiling and wall mounting

2-year warranty:

The warranty covers a period of 2 years from the date of purchase in Poland and is valid only with the purchase document – receipt or invoice.
The warranty does not cover damage caused by overvoltage, lightning strikes and mechanical damage.
The warranty is valid only if the luminaire has been installed by a person with appropriate electrical qualifications and covers the repair or replacement of the product with a product free from defects or a refund of the amount paid.
In the event of a defect, the product should be sent to the following address: Temar sp.z o.o. , 39-300 Mielec, ul. 12 investors or pay back at the point of purchase. The repair should not take more than 14 business days.
The guarantee does not exclude, limit or suspend the rights of the buyer resulting from the provisions on the warranty for defects in the sold item.

ATTENTION! TURN THE HOUSING WITH A STRONG, DYNAMIC MOVEMENT