UPLIFT ACOUSTICS ACU062 Panel Clamp Mount Instruction Manual
- October 26, 2023
- UPLIFT ACOUSTICS
Table of Contents
How To Create Digital Clock Using H...
How To Create Digital Clock Using HTML CSS & JavaScript _ Display Time Using JavaScript
UPLIFT ACOUSTICS ACU062 Panel Clamp Mount Package Contents
- Flat-head screws (qty 4)
- figs. 2 – put clamp over front part first. fig. 3 – put back clamp over back part of bracket, then tighten.
- fig. 1 – clamp on back of desk Clamp bracket (qty 2) Support bracket (qty 2)
- On the Acoustic Privacy Panel, before attaching hardware, re-move the material from the pre-cut holes with your fingertip or pencil. You should be able to spot these pre-cut holes near the bottom of the panel. See next page for dimensions and hole locations. If you are in-stalling a lot of panels, you may want to purchase our Acoustic panel hole template (ACU033).
- Line up the pegs on the Support bracket with the holes on your Acoustic Privacy Panel, and push them inside so the Support bracket is flush with the panel. The long end of the Support bracket should point towards the floor as shown. From the other side, line the Clamp bracket up with those holes. Insert the Flat-head screws and tighten until snug. Do not over tighten
- Loosen both clamps so that the opening is wide enough to slide onto your desk. The included hardware will fit desktops between 0.75’’ and 1.75’’ thick.
- Once on the back of the desk, center the panel and tighten the clamps onto your desktop (see figure 1)
Note: If you’re attaching a Side Acoustic Privacy Panel, first slide the front clamp over the front of the Frame’s Side bracket. Then, slide the back Clamp over the back of the Side Bracket. Once both clamps are around the bracket, center the panel and tighten the clamps over bracket (see figures 2 & 3).
CAUTIONS & WARNINGS
CAUTION: Read all instructions before assembly. Failure to assemble properly may result in damage
Acoustic Privacy Panel Dimensions
Side Panel
Each pair of the Side panel model’s mounting holes are located 1.5’’ from each
end, and 1.75’’ from the bottom. 22’’
Back Panels
On every Back panel model, each pair of mounting holes are located 6.5’’
from each end, and 3.35’’ from the bottom
Copyright Notice: This guide is a component of the UPLIFT Desk Acoustic Privacy Panel. This guide is a part of the scope of delivery, even if the item is resold. This guide is also available on the UPLIFT Desk website: upliftdesk.com. Excerpts or copies may not be forwarded to third parties or used in any other published form without the prior written consent of UPLIFT Desk. These instructions are subject to United States copyright law.
CONTACT: 800-349-3839
info@upliftdesk.com
upliftdesk.com