UPLIFT ACOUSTICS ACU015 Freestanding Acoustic Privacy Panel Instruction Manual
- June 12, 2024
- UPLIFT ACOUSTICS
Table of Contents
UPLIFT ACOUSTICS ACU015 Freestanding Acoustic Privacy Panel
Package Contents
-
Base
-
Base pad (qty 4)
-
Lower post
-
Upper post
-
Side cap (qty 2)
-
Top cap (qty 1)
-
Crossbar
-
M5x8 Flathead screw (qty 2)
-
M5x40 Long screw (qty 3)
-
M5x8 Buttonhead screw (qty 2)
-
M5 Washer (qty 3)
-
M5 Nut (qty 2)
-
Allen wrench
-
Flat wrench
To be used with –
Acoustic Privacy Panels (40’’-72’’)
Assembly instruction
Step 1
Line up the holes of the Lower post with the holes on the base. If they don’t
line up, flip the Base over. Connect the two parts together with two M5x8
Flathead screws.
Then apply the four Base pads to the bottom side of the Base.
Step 2
Fit the Crossbar onto the Upper post. Make sure each arm from the Crossbar
extends over the sides of the post that has the holes. Connect the two parts
together through the top of the Crossbar using a M5x40 Long screw and a M5
Washer.
Step 3
Fit the Side caps onto each end of the Crossbar and attach using one M5x8
Buttonhead screw each.
Note: leave these screws slightly loose until Step 5.
Step 4
Follow the diagrams at the left to set the height of the frame for the panel
size.
Once the holes are aligned, insert two M5x40 Long screws
through both posts where indicated by the arrows. On the other side of the
post, install an M5 Washer and an M5 Nut on the other end of each screw. Hold
the Nuts in place with the Flat wrench and tighten the Long screws using the
Allen wrench until the upper post is secure.
40’’ panel
| 52’’ panel| 64’’ panel|
72’’ panel
---|---|---|---
| | |
Step 5
Depending on ceiling height, you may need to tip the frame assembly on its
side for this step.
When the frame height is set, slide one of the panels into one side of the
frame through the Side caps and bottom of Lower post as shown. Once the first
panel is in place, push the Side caps up against the edges of the panel and
tighten the two screws from Step 3.
Then install the second panel in the same way as the first panel, but on the
opposite side of the frame.
Finally, align the Top cap with the center of the tops of the panels and press
into place so it is flush with the tops of the panels.
This will keep the panels parallel and keep them from bowing over time.
CAUTIONS & WARNINGS
CAUTION: Read all instructions before assembly. Failure to assemble properly may result in damage or personal injury.
Customer Support
Copyright Notice: This guide is a component of this accessory. This guide is a part of the scope of delivery, even if the item is resold. This guide is also available on the UPLIFT Desk website: upliftdesk.com. Excerpts or © copies may not be forwarded to third parties or used in any other published form without the prior written consent of UPLIFT Desk. These instructions are subject to United States copyright law.
© UPLIFT Desk
800-349-3839
info@upliftdesk.com
upliftdesk.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>