PIPE DECOR 365KT1 Poker Kitchen Table Instruction Manual
- June 12, 2024
- PIPE DECOR
Table of Contents
PIPE DECOR 365KT1 Poker Kitchen Table
Product Information
| Component | Quantity | Size |
|---|---|---|
| Flanges | 8 | Standard (3/4 inch) |
| Pipe (10 inch) | 4 | 10 inch length, standard (3/4 inch) |
| Pipe (8 inch) | 4 | 8 inch length, standard (3/4 inch) |
| Pipe (36 inch) | 1 | 36 inch length, standard (3/4 inch) |
| Tees | 6 | Standard (3/4 inch) |
| Hardware Screws | 16 | N/A |
This kit is made of industrial-grade authentic pipe. It is coated in oil post-
production to prevent rust. However, it is recommended to clean and seal the
kit to prevent rusting. Please refer to the “Clean and Seal” sheet for
detailed instructions on
how to clean and seal your pipe kit.
Product Usage Instructions
- 2 X Flanges (A)
- 1 X 8 inch Pipe (B)
- 1 X Tee (C)
- 1 X 18 inch Pipe (D)
- 1 X 10 inch Pipe (E)Assemble each leg with the following components:
- Refer to Box 1 for the assembly diagram. Repeat the same assembly
- Assemble the middle connectors with the following components:
- 2 X Tees (C)
- 1 X 36 inch Pipe (F)
- Connect the legs and screw in the flanges to your tabletop. (Table top is not included.)
- Loosen or tighten the flanges to level the table, and screw them into the tabletop. It is recommended to use pads to prevent scratching the floor.
Recommended Tools
The following tools are recommended for attaching the legs to the tabletop:
- Hardware screws (16 included in the kit)
We take pride in our customer service and your satisfaction is very important to us. If you have any questions or problems please contact us right away at help@jsupplies.com. Thank you for your business!
This kit is made of industrial-grade authentic pipe. It is coated in oil post- production to prevent rust. The kit should be cleaned and sealed to prevent rusting. See the Clean and Seal sheet for more information on cleaning and sealing your pipe kit.
- Assemble Each leg with a 2 X FLANGE (A) 1 X 8 IN PIPE (B), 1 X TEE(C), 18 IN PIPE (D), and 10 IN PIPE (E) as shown in Box 1. Repeat with other legs
- Assemble the middle connectors with 2 X TEES (C) and 1 X 36 IN (F) pipe.
- Connect the legs and screw in the flanges to your tabletop. (tabletop not included)
- Loosen or tighten flanges to level the table, and screw them into the tabletop Flanges may scratch the floor, and pads are recommended.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>