CAMWOOD WT-06 Wireless Receiver for Guitar User Manual

WT-06 Wireless Receiver for Guitar
User Manual CAMWOOD WT-06

INTRODUCTION

Thanks for your attention to our WT-06, the wireless set. The system handles 2.4GHz public frequency, steadily transmitting, the effected distance is 30 meters, Automati-cally frequency hopping, High Anti- interference, without any delay, Plug and play.

DIMENSION

PARAMETER

FUNCTION INTRODUCTION

1.  The light of Signal Matching : The light will be on when it’s matched successfully.
2. Power Light: The light will be on when the system is working.
3. Charging: The light will be red when it’s charging.
4. CATCH: For Matching.
5. POWER: Press and hold for seconds to turn on/off the system
6. Type-C: Charging pocket
7. 6.35mm Jack: For connecting with the endpin of the guitar or amplifier.

INSTALLATION ILLUSTRATION

CHARGING ILLUSTRATION’

MATCHING  WAY OF WIRELESS SYSTEM

1. Press and hold for seconds to turn on the Receiver, then press the Catch once, it’ll be in the matching condition when the matching light is sparkling.
2. Press and hold for seconds to tum on the Transmitter, then press the Catch once, it’s matched successfully when the lights of the Transmitter and receiver on at the same time.
   • Please make sure to handle the above steps in 30cm-30m.

CUT THE CHANNEL

Press the ‘CATCH” of the Transmitter or Receiver once, the matching lights both of them are sparkling, then, press the “CATCH’ of either system once. when the matching lights are on both of the systems at the same time. it’s successfully to cut the channel.

PRECAUTION

1. Please read the manual before using it.
2. The unit is precision electronic product. it will be regarded to give u p the warranty if it’s refit it by self.
3. Please keep it in Dry condition.
4. If you don’t use this wireless system in a long time, please do not keep turning on the power, please use the charger which it’s not more than 5V and 500Ma. when the system is in the low battery, please turn it off, then charge it according to the above steps.
5. For Better protecting the system and avoid any inconvenience. please make sure the battery situation 8 hours before the show. please make the charge when its in low battery:and For better protecting the battery, please charge it every three months, it’s not a good suggestion to turn on the system if you’re not going to use it.

WARNING

| If there is any situation happened as follows, please turn off power immediately
---|---
. 1.If there’s any smoke or unusual smell;
2.There’s some objects fallen into the unit or the liquid spilled onto it
3.The system has been wet or damp;
4.There’s any condition or any obviously changes caused the system can’t work normally.
| Please keep the objects (e.g. flammable material, coin, pins), or any kind of liquids (water, soft drinks etc.) away from the system.
| Please keep the unit aw ay from the intense bombardment or drop it.
| Please keep it aw ay from the high heating,e.g. sunlight or fire or the like.
| Please Don’t try to fix this unit or change any parts inside (unless it ‘s shown the specific instruction guiding you t o do so). Please contact your wholesaler or distributor when the system needs to be repaired.
****| Regard to the build-in battery, Please discard the used battery according to the law of your country.
| Please don’t put the system under the following Situation:
1. The places in the extremely temperature.
2. Moisture Condition.
3.The place in steamed and flue gas condition.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However. there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception which can be determined by tuming the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help

NOTE: This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter

Fuzhou DiDiao Musical Instrument Co., LTD
No.5 store, Ground floor, Block 9, Ziyang New Garden,
38 Yuefeng South Road, Jin ‘an District,
Fuzhou City, Fujian Province, China
86-0591-83590826
Franswuchuanfei@sina.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>